How to change the direction of the drain hose | Before Using | ||
| |||
1. Dismount the back cover of the washing machine. | 3. Dismount the protecting cover of the drain | ||
2. Put down the drain hose. Take off the drain hose | outlet at the other side ( method the same as | ||
frame. As indicated in Figure 1, | put the drain hose | the drain hose bushing). Install the drain hose | |
into the cabinet. Then put one hand into the cabinet | bushing as per indicatedin Figure 4. | ||
to nip the claw of the drain hose bushing to release | 4. Extend the drain hose from the other side. | ||
the claw from original position. Take off the drain | Fix the drain hose onto the cabinet with the | ||
hose bushing with the other hand. (As indicated in | drain hose rack. (As indicatedin Figure 5) | ||
Figure 2 and 3). |
|
| ••••• •••• •••••••••••• |
drain hose |
|
| |
drain hose | bushing |
| |
|
|
| Fi gur e 4 | Fi gur e 5 |
drain hose frame | drain protecting cover | dr ai n | hose bushing | |
Figure1 | cabinet | Fi gur e 2 |
|
|
i nner |
|
| ||
drain hose bushing |
|
| ||
| Push |
|
| |
hose bushing | claw | t ake off |
|
|
|
|
| ||
| Push | Figure 3 |
| Fi gur e 6 |
|
|
| ||
|
|
|
| |
Attention: To guarantee the proper installation, it is suggested to have the direction changing of drain hose performed by the
Useage the drain hose
The drainage shall be smooth with the drain hose. 
The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.
Do not step on or press the drain hose.
<10cm
If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
>
30mm
<1.5m
If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.
If the extra hose is too long,cut it either at A or at B point.
AB