Complete Installation

1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check that you have all of your tools.

3.Dispose of/recycle all packaging materials. Keep the plastic foam for use if the washer/dryer should be transported.

4.Check the washer/dryer’s final location. Be sure the vent is not crushed or kinked.

5.Check that the washer/dryer is level and front leveling feet are tight. See “Level Washer/Dryer.”

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet. Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

6.Plug into a grounded 3 prong outlet. Turn on power.

7.Check that the water faucets are on.

8.Check for leaks around faucets and inlet hoses.

9.Remove the blue protective film on the console and any tape remaining on the washer/dryer.

10.Read the Washer/Dryer User Instructions.

11.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

12.To test the washer, measure 1⁄2 the normal recommended amount of detergent and pour it into the washer. Close the lid. Select HEAVY DUTY and pull out the Cycle Control knob. Allow the washer to complete one whole cycle.

13.To test the dryer, set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

Washer/dryer is plugged into a grounded 3 prong outlet. Start button has been firmly pushed.

Electrical supply is connected.

Household fuses are intact and tight, or circuit breakers have not tripped.

Dryer door is closed.

14.When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you do not feel heat, turn off the dryer and check to see whether the gas supply line shutoff valve is open.

If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above.

If the gas supply line shutoff valve is open, contact a qualified technician.

W10222384A

© 2008.	Benton Harbor, Michigan 49022	10/08
All rights reserved.	TM DURASAFE is a trademark of Whirlpool, U.S.A.	Printed in U.S.A.