Washer/Dryer Dimensions
15 3⁄8 "
(391 mm)
71 ¾"
(1822 mm)
32 1⁄8 "
(816 mm)
*27 ¼" |
|
(692 mm) | 23 7⁄8 " |
| (606 mm) |
*Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”
Installation spacing for recessed area or closet installation
The following spacing dimensions are recommended for this washer/dryer. This washer/dryer has been tested for spacing of 0" (0 mm) clearance on the sides, rear and top. Recommended spacing should be considered for the following reasons:
Additional spacing should be considered for ease of installation and servicing.
Additional clearances might be required for wall, door, and floor moldings.
Additional spacing on all sides of the washer/dryer is recommended to reduce noise transfer.
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
Mobile home installations require:
Metal exhaust system hardware, which is available for purchase from your dealer.
Mobile Home Installation Kit Part Number 346764. See “Tools and Parts” section for information on ordering.
Special provisions must be made in mobile homes to introduce outside air into the dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening.
DrainSystem
The washer/dryer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Select the drain hose installation method you need. See “Alternate Parts.”
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of
2" (51 mm). The minimum
The top of the standpipe must be at least 39" (991 mm) high and no higher than 96" (2.4 m) from the bottom of the washer.
39" |
(991 mm) |
AB
Laundry tub drain system (view C)
The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 34" (864 mm) above the floor
1" | 237⁄8" | 1" |
(25 mm) | (606 mm) | (25 mm) |
| A |
|
|
| 1" |
|
| (25 mm) |
|
| 48 in.2 |
|
| (310 cm2) |
|
| 24 in.2 |
|
| (155 cm2) |
1"* | 27¼" | 5"** |
(25 mm) | (692 mm) | (127 mm) |
| B |
|
3" (76 mm)
3" (76 mm)
C
and no higher than 96" (2.4 m) from the bottom of the washer.
Floor drain system (view D)
The floor drain system requires a siphon break that may be purchased separately. See “Alternate Parts.”
The siphon break must be a minimum of 28" (711 mm) from the bottom of the washer. Additional hoses might be needed.
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
*Required spacing
**Rear clearance may be 0" (0 mm) when house exhaust system is lined up directly with dryer exhaust.
Mobile Home - Additional Installation Requirements
This washer/dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280).
34"
(864 mm)
CD
4