WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death.
–Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
–WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any phone in your building.
•Clear the room, building, or area of all occupants.
•Immediatelyinstructions.call your gas supplier from a neighbor's phone. Follow the gas supplier's
•If you cannot reach your gas supplier, call the fire department.
–Installation and service must be performed by a qualified installer, service agency, or the gas supplier.
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.
If using a ball valve, it shall be a
A flexible gas connector, when used, must not exceed 3 feet.
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70.
INSTALLATION INSTRUCTIONS
ToolsandParts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Parts needed for washer (not provided):
Inlet hoses |
| Flat washers |
| ||
|
To order:
Call the dealer from whom you purchased your washer/dryer.
Call the
Visit the website listed on the cover of the Washer/Dryer User Instructions.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates for future reference.
2
Tools needed:
8" or 10" adjustable wrench (for gas connections)
Adjustable wrench that opens to 1" (25 mm) or 9⁄16" (14 mm)
Level
¼" nut driver or socket wrench (recommended)
Tin snips (new vent installation)
Caulking gun and compound (for installing new exhaust vent)
Level
Knife
Vent clamps Pliers
Wood block (for leveling) Ruler or measuring tape