REVERSING THE DOOR
Hole cap
Hinge assembly
Cover cap
1Open the door and remove the two plastic hole caps on the catch side by gently prying up with a flat blade screwdriver. Save these for step 6.
CAUTION
Support the weight of the door when removing the screws in the next step. Failure to properly support the weight of the door could result
in property damage, damage to the dryer, or personal injury.
Hinge Screw
4Remove the 4 screws securing the hinges to the door frame. Remove the two plastic cover caps. Reinstall the hinges and cover caps on the opposite sides from which they were removed.
5With the hinges and cover caps in the new locations, remount the inner door frame onto the outer door frame with the screws removed in step 3 above.
2While supporting the door, remove the 4 screws, two from each hinge. Set the door aside face down on a protected surface to prevent damage to the door or the work surface.
inner door frame
latch hook
3With the door on a protected surface, remove the 12 screws on each side of the door and lift off the inner door frame using a flat blade screwdriver. Remove the latch hook and blank and move them to the opposite side.
6Reinstall the door with the screws from step 1,2.
Swing Door
7Test the swing of the door to make sure the hinges and latch are properly aligned and that the door closes and latches correctly.
12