![](/images/new-backgrounds/1293528/29352841x1.webp)
CONNECTING ELECTRIC DRYERS (cont.)
USA ONLY
wWARNING:
•Connect the power cord to the terminal block. Each colored wire should be connected to same color screw. Wire color indicated on manual is connected to the same color screw in block. Failure to follow these instructions may result in a short or overload.
•Grounding through the neutral conductor is prohibited for: (1) new
Three-Wire Connection for Electric Dryers: Power Cord
• A | • Use a 30 A, 240 V, | |
construction after January 1, 1996. | with #10 | |
• A | and closed loop or forked terminals with | |
upturned ends. | ||
|
ENGLISH
Terminal
Block
Strain Relief |
Hot | Neutral | Hot | |
(White) | |||
(Black) | (Red) | ||
|
Ground Screw
Ground
Wire
1Remove the terminal block access cover on the upper back of the dryer. Install a
240 V,
2Attach the two hot leads of the power cord to the outer terminal block screws. Attach the neutral wire to the center terminal block screw. Connect the external ground (if required by local codes) to the green ground screw. Tighten all screws securely. Reinstall the terminal block access cover.
21