ENGLISH
Thank you for purchasing a JVC product.
Please read all instructions carefully before operation, to ensure your complete understanding and to
obtain the best possible performance from the unit.
INFORMATION (For U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT FOR LASER PRODUCTS
1.CLASS 1 LASER PRODUCT
2.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.
3.CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.
Warning: | Caution on volume setting: |
If you need to operate the unit while driving, | Discs produce very little noise compared |
be sure to look ahead carefully or you may | with other sources. Lower the volume |
be involved in a traffic accident. | before playing a disc to avoid damaging |
| the speakers by the sudden increase of the |
| output level. |
How to reset your unit
How to forcibly eject a disc
If a disc cannot be recognized or cannot be ejected, eject the disc as follows.
This will reset the microcomputer. Your preset adjustments will also be erased.
•If this does not work, reset your unit.
•Be careful not to drop the disc when it ejects.
2