Maintenance and cleaning
Water tank
13
The moisture in the damp laundry is taken from the clothing and condensed. Drain the water tank after each drying cycle or during drying when the tank full warning LED comes on.
Important!
Condensed water is not drinkable!
Never remove the water tank when the programme is running!
The water tank is located inside the drawer on the panel. If you forget to drain the water tank, your machine will stop during the cycle when the water tank is full and the tank full warning LED will light up. If this is the case, press the Start/Pause/Cancel button to resume the drying cycle after draining the water tank.
To drain the water tank, carefully remove the water tank by pulling the drawer.
Fig.9 Emptying the water tank
1Drain the water by opening the water tank cover.
2If there is lint accumulation in the water tank cover, clean it and press to close.
3Place the water tank back into its seat.
Condenser
Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the humid air circulating in your machine is condensed and then pumped into the tank.
Clean the condenser after every 20 drying cycles or once a month.
To clean the condenser
If a drying process has been carried out, open the door of the machine and wait until it cools down.
1Open the kick plate, unlock the four condenser locks, and pull out the condenser.
2Clean the condenser with pressurised water and wait until the water drains.
3Replace the condenser with the side labelled “Top” facing upwards.
4Lock the four condenser locks. Make sure that the red lock on the upper right corner is engaged securely.
5Close the kick plate cover.