Fisher & Paykel DE60F60NW1 Electrical connection, Connection to a water drain

Page 7

Installation instructions

Electrical connection

5

Connect the machine to an earthed outlet protected by a fuse of suitable capacity.

Important!

Connection should comply with national regulations.

Power cord plug must be within easy reach after installation.

The voltage and the allowed fuse protection are specified in the section ‘Technical specifications’ (page 4).

The stated voltage must match with your mains voltage.

Connection via extension cords or multi-plugs should not be made.

The main fuse and switches must have a contact distance of minimum 3 mm.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

The appliance must not be operated unless it is repaired! There is the risk of electric shock!

Products equipped with a condenser unit accumulate water during the drying cycle, which is collected in the water tank. The accumulated water should be drained after each drying cycle.

Connection to a water drain

The Tank Full warning LED will light up at the end of each programme.

You can directly send the accumulated water out through the water drain hose supplied with the machine instead of periodically draining the water collected in the water tank.

Connecting the water drain hose:

1Remove the hose on the machine by pulling it out from its end. Do not use any tools to take out the hose.

Attach the drain hose adaptor to the end of this hose.

Fig.2 Connecting to a water drain

2Connect the special drain hose supplied with the machine to the hose adaptor fitting.

3The other end of the drain hose can be directly connected to the wastewater drain or to the washbasin. The fitting must always be secured in all types of connections. Your house may be flooded if the hose gets out of its housing during water discharge.

Important!

The hose should be attached to a maximum height of 800 mm.

You must be careful not the pinch or bend the hose.

The end of the hose should not be bent, it should not be stepped on and it must not be folded between the drain and the machine.

Image 7
Contents Installation instructions Page Contents First use Safety and warningsGeneral safety Safety instructionsIf there are children in your house Levelling Installation instructionsTechnical specifications Proper locationConnection to a water drain Electrical connectionLoading door Before dryingPreparing clothes to be dried Correct load capacityTurning the machine on Control panelProgramme selection Main programmes Progress of programme Auxiliary function Buzzer cancelFilter cleaning Water tank Starting the programmeChanging the programme after the programme has started Adding/removing laundry in standby modeChildproof lock End of programme Ending the programme through cancellingLint filter Maintenance and cleaningFor filter cleaning For sensor cleaningWater tank To clean the condenserCondenser Problem Cause Explanation / Suggestion TroubleshootingProblem Cause For Australian Customers Manufacturer’s WarrantyThis Warranty does not cover Fisher & Paykel undertakes toProduct details Model/Serial No Before you call for service or assistance…Customer Care Australia if you need assistancePN 790817 D 07.2011