Troubleshooting, End/Anti-creasing symbol is on

7Troubleshooting

Drying process takes too much time.

•Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.

•Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.

•Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any) that block ventilation in front of the ventilation grids.

•Ventilation is not sufficient since the room where the machine is installed is very small. >>> Open the door and window of the room to avoid the room temperature increase too much.

•Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.

•Excessive laundry is loaded. >>> Do not load the dryer in excess.

•Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing machine.

Laundry comes out wet at the end of drying.

C After drying, the hot clothes feel damper than their actual dampness level.

•It is likely that the selected programme did not suit the laundry type.>>>Checking the care labels on clothes, select appropriate programme for the laundry type or use timer programmes in addition.

•Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.

•Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.

•Excessive laundry is loaded. >>> Do not load the dryer in excess.

•Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing machine.

Dryer does not switch on or the programme does not start. Dryer does not start when it is set.

•It is not plugged in. >>> Make sure that the machine is plugged in.

•The loading door is ajar. >>> Make sure that the loading door is closed securely.

•Programme is not selected or the Start / Pause / Cancel button is not pressed. >>> Make sure that the programme is selected and the machine is not in Pause mode.

•Childproof Lock is activated. >>> Deactivate the Childproof Lock.

Programme is interrupted without any cause.

•Loading door is ajar. >>> Make sure that the loading door is closed securely.

•There was a power failure. >>> Press Start / Pause / Cancel button to start the programme.

•Water tank is full. >>> Drain the water tank.

Laundry has shrunk, become felted or deteriorated.

•A programme suitable for the laundry type is not used. >>> Check the garment tag and select a programme suitable for the fabric type.

Drum lighting does not turn on. (On models with lamp)

•Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is switched on.

•Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced.

End/Anti-creasing symbol is on.

•Anti-creasing programme is activated in order to prevent laundry that has remained in the machine from creasing. >>> Turn off the dryer and take out the laundry.

End symbol is on.

• Programme is over. Turn off the dryer and take out the laundry.

28 / 32 EN	Dryer / User Manual