Sony CDP-XE500, CDP-XE200, CDP-XE300 manual Troubleshooting, Specifications

Additional Information

Troubleshooting

If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.

There’s no sound.

/Check that the player is connected securely.

/Make sure you operate the amplifier correctly.

/Adjust the output level with LINE OUT LEVEL +/– on the remote (CDP-XE500 and CDP-XE300 only).

The CD does not play.

/There’s no CD inside the player (“no dISC” appears). Insert a CD.

/Place the CD with the label side up on the disc tray correctly.

/Clean the CD (see page 14).

/Moisture has condensed inside the player. Remove the disc and leave the player turned on for about an hour (see page 2).

The recording level has changed (CDP-XE500 and CDP- XE300 only).

/The recording level changes if you adjust the output level with LINE OUT LEVEL +/– on the remote during recording.

The remote does not function (except for CDP-XE200).

/Remove the obstacles in the path of the remote and the player.

/Point the remote at the remote sensor g on the player.

/Replace all the batteries in the remote with new ones if they are weak.

Specifications

Compact disc player

Laser		Semiconductor laser (λ = 780 nm)
		Emission duration: continuous
Laser output		Max 44.6 μW*
		* This output is the value measured at
		a distance of 200 mm from the
		objective lens surface on the Optical
		Pick-up block with 7 mm aperture.
Frequency response		2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio		More than 100 dB
Dynamic range		More than 98 dB
Harmonic distortion		Less than 0.0045%
Channel separation		More than 95 dB
Outputs
	Jack	Maximum	Load
	type	output	impedance
		level
LINE OUT	Phono	2 V	Over 10 kilohms
	jacks	(at 50 kilohms)
DIGITAL	Optical	–18 dBm	Wave length: 660 nm
OUT	output
(OPTICAL)	connector
(CDP-XE500
only)
PHONES	Stereo	10 mW	32 ohms
(CDP-XE500	phone
only)	jack
General
Power requirements		220 V – 230 V AC, 50/60 Hz
Power consumption		10 W
Dimensions (approx.)		430 × 95 × 295 mm
(w/h/d)		(17 × 3 3/4 × 11 5/8 in.) incl. projecting
		parts
Mass (approx.)		CDP-XE500: 3.0 kg (6 lbs 10 oz)
		CDP-XE300/XE200: 2.9 kg (6 lbs 7 oz)

Supplied accessories

Audio cord (2 phono plugs – 2 phono plugs) (1) Remote commander (remote) (except for CDP-XE200) (1) Sony SUM-3 (NS) batteries (except for CDP-XE200) (2)

Design and specifications are subject to change without notice.

15EN