Recording From CDs
To check and change your program
See page 11.
The 
indication appears while checking the program
for side A and while checking the program for side B.
When tracks, which aren’t numerically consecutive on the disc, are programmed consecutively (i.e. 1, 3, 5 etc.)
A
Recording a CD by Specifying Tape Length (Time Edit)
You can have the player create a program that will fit the length of the tape.
The player automatically creates a program, keeping the original order of the disc.
The program can contain up to 24 tracks (a pause inserted between tracks is counted as one track). Note that tracks whose numbers are over 24 cannot be programmed automatically.
EDIT/TIME FADE | · | 0 / ) |
1Press EDIT/TIME FADE before you start playing
until EDIT appears and “A” in the 
indication flashes in the display.
2Press 0 or ) to specify the tape length. Each time you press these buttons, the display changes as shown below, with the tape length of one side following each indication.
nHALF ˜
When you select “HALF”
The player sets the program of each side to a half of the total playing time of the disc. Note that you cannot select “HALF” when the disc has more than 24 tracks.
3Press EDIT/TIME FADE to have the player create the program.
The display shows the tracks to be recorded. “B” in
the 
indication flashes in the display.
4When you record on both sides of the tape, press EDIT/TIME FADE again.
The player inserts a pause, then creates the program for side B. The display shows the programmed tracks.
When you record on one side of the tape or on a DAT or MD, skip this step.
5Start recording on the deck and then press ·on the player.
When you record on both sides of the tape, the player pauses at the end of the program for side A.
6When you record on side B, reverse the tape and press ·or P on the player to resume playing.
To cancel Time Edit
Press PLAYMODE until “SHUFFLE” and “PROGRAM” disappear from the display.
When using the remote, press CONTINUE.
You can program the tracks you want in advance
Select the tracks before doing the above procedure. The player creates a program from the remaining tracks. In this case, you cannot select “HALF” to specify the tape length.
You can freely specify the tape length
Set the tape length using ≠ AMS ± .
Example: When the tape length of one side is 30 minutes and 15 seconds
1To set the minutes, turn ≠ AMS ± until “30” appears in the display, then press
ENTER .
2To set the seconds, turn ≠ AMS ± until “15” appears in the display, then press
ENTER .
When tracks, which aren’t numerically consecutive on the disc, are programmed consecutively (i.e. 1, 3, 5 etc.)
A
To check and change your program
See page 11.
12EN
