Recording From CDs
Fading In or Out
You can manually fade in or out to prevent tracks from starting or ending abruptly.
Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector (for
Fading in or out at the point you want (except for
FADER
To | Press FADER |
|
|
Start play fading in | During pause. The Q indication |
| flashes and play fades in. |
|
|
End play fading out | When you want to start fading out. |
| The q indication flashes. The play |
| fades out and the player pauses. |
|
|
Fading time lasts for 5 seconds. If you press FADER during Music Scan (page 8), fading time changes to 2 seconds.
Fading out at the specified time (Time Fade) (CDP-XE500 only)
You can have the player fade out automatically by specifying the playing time. Once you set the time fade, it works twice, that is, the play fades out at the end of both sides of a tape.
EDIT/TIME FADE | · | 0 / ) |
1Press EDIT/TIME FADE repeatedly before you
start playing until “ ” and “A” in the 
indication appear in the display.
2Press 0 or ) to specify the playing time. Each time you press these buttons, the display changes as shown below, with the playing time of one side following each indication.
nHALF ˜
When you select “HALF”
The player sets the playing time to a half of the total playing time.
3Press ·to start playing.
At the specified time the play fades out and the
player pauses. “B” in the 
indication appears in the display.
4To record on side B, reverse the tape and press · or P on the player to resume playing.
Again, the play fades out at the specified time.
To cancel Time Fade
Press EDIT/TIME FADE.
You can freely specify the playing time
See “You can freely specify the tape length” on page 12 .
You can change discs during Time Fade
If the play ends before the specified
You can fade in to resume playing in Step 4
After you reverse the tape, press FADER on the remote.
Note
Time Fade will be cancelled if you press 0 or ) during the operation.
13EN
