Troubleshooting
Should you encounter problems with your scanner, refer to the following section and the trouble- shooting section in the Nikon Scan 3 Reference Manual before consulting your retailer or Nikon representative.
Problem |
| Possible Cause |
|
|
|
|
| • The power cable is not properly connected |
|
| After confirming that the scanner is off, reconnect the power |
|
| cable. |
The scanner does not turn |
| • The scanner is off |
on (the status LED does not |
| Turn the scanner on. |
light) |
| • The power supply to scanner has been interrupted |
|
| Try plugging a different device into the outlet used by the |
|
| scanner to determine whether the problem is caused by a |
|
| failed fuse or circuit breaker. |
|
|
|
|
|
|
|
| • The |
|
| Turn the scanner off, remove the |
The status LED flashes |
| ner on again. |
rapidly (scanner not |
| • A scanner hardware malfunction has occurred |
connected to computer or |
| Turn the scanner off and disconnect it from the computer. |
computer off) |
| Wait five seconds, then turn the scanner on again. If the |
|
| problem persists, contact your retailer or Nikon service rep- |
|
| resentative for advice. |
|
|
|
25
28
–
–
–
