En Keep the Adapter Slot Closed
In order to ensure that your scanner always produces the best possible results, remove the adapter and close the sliding cover when the scanner is not in use.
Never remove an adapter from the scanner without first ejecting the film and check- ing that the status LED on the front of the scanner is glowing steadily. Do not insert or remove adapters, insert or eject film, or turn the scanner off while the LED is blinking.
After using the scanner, eject the film from the adapter and turn the scanner off, then remove the adapter and close the sliding cover.
Choose a Location
Before connecting the power and interface cables, choose a flat, stable location for your scan- ner close to the computer and to a suitable power outlet. Do not install your scanner where:
it would be exposed to direct or reflected sunlight
it would be subject to condensation or to drastic changes in temperature
it would be exposed to dust or smoke
it would be exposed to water vapor from a humidifier
it would be exposed to radio interference from other electronic devices
the temperature exceeds 35°C (95°F) or falls below 10°C (50°F)
other objects would block the scanner’s vents
The scanner has feet on two sides, allowing it to be installed in either of the orientations shown below. Leave enough space around the scanner to ensure ease of operation: at least 5 cm (2˝) above and on either side of the scanner, and 10 cm (4˝) behind it. When using the
6
