Nikon LS4000 user manual Get to Know Your Scanner

Get to Know Your Scanner	En
Your Scanner

￿

￿

4000 ED/COOLSCAN IV ED

￿

Front

View ￿ ￿

￿

	Rear		￿
	View
4000 ED			COOLSCAN IV ED
	￿	￿

￿Status LED

This LED blinks slowly (roughly twice every three seconds) when the scanner is in op- eration. Do not turn the scanner off, remove or insert adapters, or eject or insert film until the LED has stopped blinking and is glowing steadily. If the LED flashes rapidly (about five times a second), a communications error has occurred or there is a problem with the scan- ner. Turn the scanner off, wait for at least five seconds, and then turn it back on.

￿Adapter slot

This is where you put adapters for different types of film. Don’t put anything in this slot except an approved Nikon film adapter.

￿Power switch

Press this switch to turn the scanner on and off.

￿Film gate for optional SA-30 roll-film adapter (4000 ED)

Open this gate only when you are using the SA-30 roll-film adapter (available separately).

￿AC connector

Connect the female end of the power cable here.

￿IEEE 1394/Firewire interface connector (4000 ED)

Connect the IEEE 1394/Firewire interface cable here.

￿Sliding cover

Slide the cover down before inserting a film adapter. To protect your scanner from dust and other foreign objects, be sure ALWAYS to close the cover when no adapter is in place.

￿Feet

Always place the scanner on one of its two sets of feet.

￿USB interface connector (COOLSCAN IV ED) Connect the USB interface cable here.

3