Auxiliary function, Starting the Programme | Beko DVTC 60 W specification

Auxiliary function

Low temperature

This function allows for drying at lower temperatures and therefore saves energy.

Warning LED will light up when you select the function.

CYou must use this function when you dry your synthetic or delicate laundry.

Warning indicators

CWarning indicators may differ according to the model of your machine.

Filter cleaning

A warning LED will light up to remind filter cleaning after the programme finishes.

CIf the filter cleaning warning LED lights up continuously, please refer to, “Solution suggestions for problems”.

Starting the Programme

1.Press “Start/Pause/Cancel” button to start the programme.

2.“Start/Pause/Cancel” button will light up to indicate that the programme has started.

Timer follow-up indicator

One of the LED lights will remain on as far as programme runs and shows the approximate remaining time.

CLEDs on the timer follow-up indicator will also flash when the child-proof lock is activated.

Changing the programme after the programme has started

You can use this feature to dry your laundry in a different programme after your machine has started to run.

For example;

Press and hold the “Start/Pause/Cancel” button for about 3 seconds to select “80” minutes programme instead of “60” minutes programme

Select the “80” minutes programme by rotating the programme knob.

Press “Start/Pause/Cancel” button to start the programme.

CThe programme which is selected first will go on even if the programme selection button is moved and another programme mode is selected while the machine is operating. You must cancel the ongoing programme in order

to change the drying programme.

(See, Ending the program through cancelling)

Adding/removing laundry in standby mode

In order to add or take out laundry after the start-up of the programme

1. Press the “Start/Pause/Cancel” button to switch the machine to “Pause” mode. Drying process will stop.

2. Open the door at Pause position and close it again after adding or taking out laundry.

3. Press “Start/Pause/Cancel” button to start the programme.

C Any laundry added after the drying process was started may cause the already dried clothes in the machine intermingle with wet clothes and the result will be wet laundry after the drying process is over.

C Laundry may be added or taken out as much as desired during a drying process, but as this process will interrupt drying continuously, it will extend the programme

duration and increase energy consumption. Therefore, it is recommended to add laundry before the drying programme is started.

Child-proof lock

There is a childproof lock to prevent any programme interruption due to the pressing of keys while the programme is on. The loading door and all keys except the “On/Off” key on the panel are deactivated when the child-proof lock is active.

In order to activate the childproof lock,

press the “Start/Pause/Cancel” and “Low temperature” buttons simultaneously for 3 seconds.To start a new programme after the programme is over or to interrupt the programme, the childproof lock should be deactivated. To deactivate the childproof lock, press the same buttons for 3 sec.