Getting Started

BEFORE USING FOR THE FIRST TIME Before beginning to use your dryer for the first time:

1.Check to make sure that the voltage on which the dryer is to operate is the same as shown on the rating plate.

2.Wipe the interior of the drum with a damp cloth.

Below, in order to get started, you will find a summary of how to operate the clothes dryer. Also, refer to the CYCLE SELECTION CHART, Table 1.

•Turn On the Dryer

Press the "ON/OFF" button. The indicator light will become illuminated and the indicator above the "START" button will begin to flash.

•Check the Lint Filter

The lint filter, located in the door, should be cleaned after or before each load.

•Load the Dryer

Load the items in the dryer.

•Add Fabric Softener Sheet

If a fabric softener sheet is to be added it should be done after loading the dryer.

•Close the Dryer Door

•Select Cycle Desired

See CYCLE SELECTION CHART, Table 1, and following section titled OPERATION for program recommendations.

•Select Additional Functions (if desired) See following section titled OPERATION.

•Press the "START" Button

The "START" indicator lamp will stop flashing and the dryer will start. If one of the Auto-Cycles have been selected the Duotronic system will monitor the moisture level and display the progress of the drying in the "Moisture Level Indicator Lights." If a timed cycle has been selected the minutes remaining will be displayed in the "Cycle Countdown Display."

The cycle will continue to the end, when the "End" indictor lamp will become illuminated. And, if the "End of Cycle Signal" has been selected a signal will sound. - See following section OPERATION on how to set or turn of the "End of Cycle" signal.

•Depress the "DOOR" Button The door will open.

•Remove the Laundry from the Dryer

•Clean the Lint Filter

•Turn Off the Dryer

Depress the "ON/OFF" button.