Timed Cycles | Bosch Appliances WTL 5400, WTA 3500 specification

3.Load the dryer

For best results it is recommended that the drying load be sorted by fabric type and desired dryness level. Also, close all zippers, hooks and eyelets and tie loose belts and apron strings, etc. before placing in the dryer.

a.Depress the "DOOR" button. The door will open and the drum light will turn on.

b.Check the drum interior for foreign objects or pets and remove any used fabric softener sheets.

c.Place laundry items to be dried loosely into the drum of the dryer.

4.Add Fabric Softener Sheet, if desired

If a fabric softener sheet is to be added it should be done after loading the dryer and before the dryer and load become warm. This will prevent greasy-looking softener stains.

5.Close the Door

Check the area around the drum opening to make sure that nothing is caught on the edge or hanging outside the drum and close the door making sure the door clicks into place and is fully closed.

Note: If the door is not fully closed the dryer will not operate.

6.Select the Drying Cycle Desired

The Bosch dryers can be operated in either the Electronic Auto Dry Cycle mode, which uses the Duotronic moisture sensing system, or in Time Cycle mode, which uses a timer to control the length of the program. See below and CYCLE SELECTION CHART, Table 1, for program recommendations:

a.To use Electronic Auto Dry Cycles

(dryer runs until the drying level selected has been reached) activate by turning the Cycle Selector knob (see Figure 3) to:

i. Regular /Cott.

The Auto-Program dial should be turned to point to the right to select Regular/Cott. settings. As the knob is turned the lights directly above the knob will illuminate to indicate the level of dryness selected, from Extra Dry through Damp Dry. See Table 1 for recommended settings for type of load being dried.

or,

ii.Permanent Press

The Auto-Program knob should be turned to point to the left to select Permanent Press settings. As the knob is turned the lights directly above the knob will illuminate to indicate the level of dryness selected. See Table 1 for recommended settings for type of load being dried.

Timed Cycles	Permanent 0	.Regular/Cott.
0(9	Press	0 Extra Dry
		o Very Dry
Heated Dry	• Regular Dry
o		o Light Dry
Air Fluff		o Econo Dry
o		o Damp Dry

Figure 3.

b.To use Time Cyles (dryer runs for selected length of time) activate by turning the time program selector (see Figure 4):

i.Heated Dry

The Time Cycle'sknob should be turned to point to the right to select the Heated Dry setting. Then depress the "Cycle Time Minutes" button to set the time interval for drying. The time can be set at 10 - 90 minutes in 10 minute steps.

or,

ii.Air Fluff (cold)

The Time Cycle'sknob should be turned to point the left to select the Air Fluff setting. Then depress the "Cycle Time Minutes" button to set the time interval for drying. The time can be set at 10 - 90 minutes in 10 minute steps.

Note: The Auto-Program knob must be pointing straight-up to use Time Cycles.

Cycle Countdown		UntFilter	TImed Cycles	Permanent 0		0 Regular/Cotl.
:.~.:r1,	J <.9	o	.<.9	Press	0	Extra Dry
t.'iDO.•'!:::..i			•		o Very Dry
			Heated Dry		o	Regular Dry
Cycle TIme					o	Light Dry
•			Air Fluff		,	Econo Dry
Minutes			Air Fluff		o	Econo Dry
I			o		o	Damp Dry

=	aD
=

Figure 4.