AEG T76280AC user manual Inactive Push the Start/Pause button

18 www.aeg.com

Problem1)	Possible cause	Remedy
	The loading door is opened.	Close the loading door.
	The On/Off button was not	Push the On/Off button.
	pushed.
	The Start/Pause button was not	Push the Start/Pause button.
	pushed.
	The appliance is in the standby	Push the On/Off button.
	mode.
	Incorrect programme selection.	Do the selection of the applica-
		ble programme. 2)
	The filter is clogged.	Clean the filter. 3)
	The Dry Plus function was in	Change the Dry Plus function
		to the moderate or maximum
	minimum mode.
		mode.
Unsatisfac-	The condenser is clogged.	Clean the condenser. 3)
tory drying	Too high volume of the load.	Obey the maximum load vol-
results.
		ume.
	The airflow grill is clogged.	Clean the airflow grill in the
		bottom of the appliance.
	Dirt on the inner surface of the	Clean the inner surface of the
	drum.	drum.
	Too high water hardness.	Set applicable water hard-
		ness4).
The door	The filter not locked in the po-	Put the filter in the correct posi-
	sition.	tion.
does not
	The laundry is locked between	Put the load correctly in the
close.
	the door and the seal.	drum.
	You try to change the pro-	Turn the tumble dryer off and
	gramme or the function after
Err (Error)		on. Make the new selection.
	the start of the cycle.
on the dis-
	The function you try to activate
play.		Turn the tumble dryer off and
	is not applicable with the selec-
		on. Make the new selection.
	ted programme.
No drum	Defective drum light.	Contact the service centre to
light 5)		replace the drum light.
Abnormally	The time to end is calculated	The automatic procedure —
elapsing
	on the basis of the volume and	this is not the appliance mal-
time on the
	dampness of the laundry.	function.
display.)

Programme	The water container is full.	Drain the water container3)	,
inactive.		push the Start/Pause button.