Haier HDY6-1 Preparation, Turning on power, Treatment of laundry to dry, Load to dry

Page 4

Installation

be removed from the box after every drying of the laundry. If your dryer is in the vicinity of a drainage, you may allow the condensate water being discharged directly into the drainage through the drainpipe provided as accessory so that to avoid emptying the box for every time. The method to connect the drainpipe is as follows:

1.Loosen the hose clip with the drain switchover joint;

2.Pull the hose off the joint;

3.Install the accessory drainpipe in place;

4.Fix the hose clip.

Note: The outlet of the drainpipe must not be higher than 1.2 m above the floor.

AB

Preparation

Attention

1.Before operation, clean off the dusts and dirties inside the drum of the dryer by a wet towel;

2.Clean off debris on the filter screen and in the duct to increase the drying efficiency.

Turning on power

Before turning on the power for the dryer, check:

Whether the supply voltage is in accordance with the value indicated on the nameplate;

Whether the supply receptacle can withstand the maximum power load to the dryer;

Whether the supply receptacle is in accordance with the plug of the dryer. If not, replace the power supply cable or receptacle to make them accord with each other; The replacement of the power supply cable must be made by a qualified professional or our authorized service agent;

The dryer must be grounded securely.

Treatment of laundry to dry

Check whether the laundry to be dried is suitable to be dried in the dryer; The dryer can only dry the laundry that has been spun dry. Do not

put too wet laundry into the machine;

Empty all pockets of the laundry with such items as keys and coins and remove the adornment that is not suitable to be dried;

Pull up zippers, sew and mend up loosened fasteners and tie up dispersed ribbons to prevent the laundry from being entangled. If necessary, put small items into a net.

To achieve a better drying result, shake the heavy laundry and make it loose before load it into the dryer.

Load to dry

Laundry type

Cotton fabric

Synthetic fabric

 

 

 

Maximum load

.J

 

 

 

 

Warning: Do not dry wool, silk, down and other delicate fabrics to avoid damage to fabrics.





Image 4
Contents Table of Contents Name of PartsImportant Safety Instructions Installation DimensionsPacking accessories = 855 mm b = 620 mm c = 595 mm Weight = 38 KgTurning on power PreparationTreatment of laundry to dry Load to dryControl panel Programming Guide Drying MethodsDegree DryingCleaning and Maintenance Cleaning the surfaceTrouble shooting Wiring Circuit SpecificationsHeat1 Bulb