Cleaning and Maintenance |
| Cleaning and Maintenance |
1Cleaning the surface
Wipe off the dusts and dirties on the body of the dryer and the surface of the main control panel by a cleaning cloth. Remember not use any organic solvent or corrosive agent in cleaning to avoid damage to the machine.
2. Cleaning the filter screen
To ensure a good ventilation effect during drying, the filter screen must be cleaned after every drying program is complete.
Open the door to remove the filter screen from the machine. Open the screen and clean
off the lints on the screen and handle by a wet towel. After cleaning, put the screen back in place.
3. Empty the condensate collection box During the operation of a program, steam
condenses into water is collected in the box. The box must be emptied in time after the program is complete.
-Hold the handle of the box and take out the box. When the box is taken out, keep it level to prevent the condensate from overflowing;
-Pour away the condensate water. Note: the condensate water can not be used for drink or for food processing;
-Put the box back in place.
If the box has not been cleaned in time, the dryer will alarm automatically when the box is full. The indicator light is on when the box is emptied and the dryer will stop. It will not restart until the box is emptied.
A
4.Cleaning condenser
The condenser must be cleaned monthly. Cut off power supply before cleaning.
- Hold the protrusions on both sides of the lower deco panel and open the lower deco panel;
-Using a coin or other tool, push the slides on the cover to the position as shown in the figure and then remove the cover;
-Turn the condenser's handle 90 degrees in the direction as shown in the figure;
-Remove the condenser from the dryer;
-Clean the condenser by a brush or flush it by a water jet;
Note: Do not use a sharp tool in cleaning the heat exchanger, otherwise it may damage its sealing performance;
-Put the condenser back in place and lock up the cover;
-Put the lower deco panel back in place.
B | C | D |
5. Cleaning the drum
After the dryer has operated for a time, fabric caring agents or calcium contained in the water will form an almost invisible segregation layer on the inside of the drum.
This makes the dryer not able to reliably and accurately identify the dryness of the laundry. So the inside of the drum, especially the stainless steel pieces on the blades must be cleaned regularly by a wet cloth.