English
Function Light Indicator:
The function "display light" indicates selected feature is "ON" or the cycle is about to begin.
During the dry cycle, "flashing light" indicates current running program. Rapidly flashing light indicates that the dryer is not operating properly.
Preparations before drying
Group the clothes of the same kind (cotton, chemical fibres, woolen) to dry. Dark and light colored clothes shall be separately dried. Fabrics prone to falling lint and those prone to adhering lint shall be separately dried. Clothes prone to falling lint shall be turned inside out before putting into the dryer.
Make sure buttons and ornaments on the clothes are high temperature resistant and won't damage drum surface. Before loading, the clothes shall have their zippers zipped up, buttons and hooks done up and belts tied so as to avoid entanglement or other obstacles.
If possible, turn out the clothes pockets for uniform drying.
Check if clothes remain soiled. If yes, wash it away again, otherwise the soils after drying may not be removed permanently.
Small articles shall be collected in a mesh bag before loading and drying, so as to avoid entanglement and ensure easy to be taken out.
Make sure power socket is reliably grounded. The grounding terminal shall not be connected to gas or tap water pipelines.
Make sure exhaust duct has been connected with extension pipe.
Make sure lint filter is clean and then assemble it properly. If lint filter is not
in place, tumbling items could enter the exhaust system and cause damage to the dryer.
Notes: It applies to Auto Dry cycle and Timed Dry cycle. For Rack Dry cycle, remove the lint filter and assemble the drying rack with its rear end slightly downward inclined. The assembled status is as shown in the following figure:
Drying rack
Drum
15