Haier GDZ22-1 Exhaust System Connections, Requirements and Instructions, Explosion hazard

Page 14

GDZ22-1 manual 10/22/01 11:45 AM Page 14

English

Exhaust System Connections

Requirements and Instructions

WARNING

The following are specific requirements for proper and safe operation of your dryer. Failure to follow these instructions can create excessive drying times and fire hazards.

1.Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up inside exhaust system and create a fire hazard and restrict air flow. Restricted air flow will increase dryer times. If your present system is made up of plastic duct or metal foil duct, replace it with a rigid or flexible metal duct. Ensure present duct is free of any lint prior to installing dryer duct.

2.If the dryer is not exhausted out doors, some fine lint will be expelled

into the laundry area. An accumulation of lint in any area of the home can create a health and fire hazard. To reduce risk of fire, dryer MUST BE EXHAUSTED OUTDOORS.

3.Do not allow combustible material (for example: clothing, draperies/curtains, paper) to come in contact with exhaust system. The dryer must not be exhausted into a chimney, a wall, a ceiling, or any concealed space of a building which can accumulate lint, resulting in a fire hazard.

4.Exceeding the length of duct pipe or number of elbows allowed in the “Maximum Length” charts can cause an accumulation of lint in the exhaust system. Plugging the system could create a fire hazard, as well as increase drying times.

5.Do not screen the exhaust ends of the vent system, nor use any screws

or rivets to assemble the exhaust system. Lint can become caught in the screen, on the screws or rivets, clogging the duct work and creating a fire hazard as well as increasing drying times. Use an approved vent hood to terminate the duct out- doors, and seal all joints with duct tape. All male duct pipe fittings must be installed downstream with the flow of air.

Explosion hazard:

Do not install the dryer where gasoline or other flammables are kept or stored. If the dryer is installed in a garage, it must be minimum of 18 inches (45.7 cm) above the floor. Failure to do so can result in death, explosion, fire or burns.

13

Image 14
Contents Electric Dryer Sèche-Linge Électrique Secador-Eléctrico Important Safety Instructions Read all instructions before using the applianceFor Future Use Warranty service Table Of Contents Features Control KnobTemperature Knob Start KnobLint Filter Other FeaturesEnd of Cycle Signal Leveling LegsOperations Normal Operating Sounds TipsCare and Cleaning Guide USE Your Dryer Without the Lint FilterDryer does not operate TroubleShootingDryer making noise when drying Dryer is working but not drying the clothesElectrical Requirements Power SupplyTools and Materials Required Unpacking Your DryerExplosion hazard Exhaust System ConnectionsRequirements and Instructions Materials English Location of Your Dryer Do Not Install Your DryerInstallation in Recess or Closet Installation in Mobile Home Electrical Connections For proper groundingWire Cord Connections Typical Conductor Cord English Limited Warranty Limited WarrantyDo Not Return This Product To The Store Haier America Trading, L.L.C New York, NY