Alliance Laundry Systems DRY684C Connecting Power Cord with Three-Wire Plug, Copper Wire Only

Installation

Connecting Power Cord with Three-Wire

Plug

NOTE: Four-wire cord is required for new branch- circuit installations, mobile homes or where codes do not permit grounding through neutral.

NOTE: The power cord is NOT supplied with the
electric dryer. Type of power cord and gauge of wire
must conform to local codes and instructions.	POWER SUPPLY	POWER SUPPLY

The method of wiring the dryer is optional and subject			1
to local code requirements.
NOTE: Connect the dryer to the power supply with the			2
MAXIMUM RATED VOLTAGE listed on the nameplate.			3
	A typical 30-	INTERMEDIATE FUSE
	Amp Three-		INTERMEDIATE
	Wire	BOX (may be omitted
			SHUT-OFF BOX
	Receptacle	if service entrance
			(may or may not
	NEMA Type	box is fused)
			be fused)
	10-30R
			4
		WALL
		RECEPTACLE	5
120 ± 12	120 ± 12		6
	V.A.C.
V.A.C.			7
	240 ± 12
	V.A.C.

	NOTE: Use COPPER WIRE only.		L1	L2			L1	L2
		POWER CORD CONNECTION				DIRECT CONNECTION
	Shorter than 15 ft. (4.5 m) – use 10 AWG
	Longer than 15 ft. (4.5 m) – use 8 AWG								D816I
1	3 Wire Grounded Neutral 120/240 Volt, 60 Hertz			4	Metallic or Non-Metallic Sheathed Cable
	AC 1 Phase Service Entrance Switch Box				(Copper Wire Only)
	(Refer to NOTE above)			5	Power Cord (Not supplied with dryer)
2	30 Ampere Fuses or Circuit Breaker			6	Neutral
3	Neutral Wire			7	Terminal Block in Dryer

1.Disconnect power to dryer.

2.Remove access cover from rear of dryer.

Figure 11

3.Use a strain relief and insert end of power cord through power supply hole.

D695I

Figure 12

D696I

Figure 13

18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 513220