e.Open main door. The dryer must stop and ALL output indicator lights on the back side of the microprocessor controller (computer) board must go out. (Refer to the illustration on the previous page.)
f.Try to restart the dryer with the main door open.
g.The microprocessor controller (computer) board’s light emitting diode (L.E.D.) display must read “DOOR.”
h.Close the main door and restart the dryer.
i.Functional check of microprocessor controller (computer) board is complete.
2.For Direct Spark Ignition (DSI) System Models Manufactured With ADC Module Part No. 880815
a. Upon completing installation of the replacement DSI module, reestablish power to the dryer.
b. Starting the drying cycle.
c. The ignition DSI module’s light emitting diode (L.E.D.) indicator will light “red” for up to approximately
d. The module’s indicator light will then turn “green.” The gas valve will be energized and the ignitor probe will spark for approximately
e.With the burner flame on, remove the flame sensor wire from the FS terminal of the DSI module.
f.The burner flame must shut off and the ignition module must lockout with the DSI module’s indicator light “red.”
g.Stop the drying cycle, with the flame sensor wire still removed, restart the drying cycle.
h.The ignition module must proceed through the prepurge, with the indicator light “red,” the ignition trial time of approximately
i.Functional check of the DSI module is complete.
1)Replace the flame sensor wire from the FS terminal to the DSI module.
52