2.Microprocessor controller (computer) indicator is off (and light emitting diode [L.E.D.] display does not read “door”)...
a.Failed microprocessor controller (computer).
C.Basket (tumbler) does not turn, but motor microprocessor controller (computer) L.E.D. dot and motor output L.E.D. indicators are on...
1.Loose basket (tumbler) belt (check tension/adjustment).
2.Basket (tumbler) belt jumped off of the motor or idler shaft.
3.Broken basket (tumbler) belt.
D.The dryer will not stop, even with no cycle (L.E.D. display reads “FILL”) in progress...
1.Failed motor contactor/relay.
E.The dryer operates for a few minutes and then stops...microprocessor controller (computer) L.E.D. display continues to read cycle in progress, indicator dots are off and dryer can be restarted by pressing selection key...
1.Intermittent connection in the main door/lint drawer circuit...
a.Main door switch or lint drawer switch out of proper adjustment.
b.Loose connections in main door or lint drawer switch wiring.
c.Failed main door or lint drawer switch.
F.The dryer does not start, and the microprocessor controller (computer) L.E.D. display reads “door”...
1.Microprocessor controller (computer) “door” input L.E.D. is off...
a.Main door and/or lint drawer is not properly closed.
b.Failed main door switch.
c.Failed lint drawer switch.
d.Open circuit (broken wire and/or termination) in main door switch wiring or lint drawer switch wiring.
2.Microprocessor controller (computer) “door” input L.E.D. is on...
a.Failed microprocessor controller (computer).
43