American Dryer Corp WDA-530D II, ADG-530D II installation manual

Page 38

2)Selection (setting) changes can be made at any time during the drying cycle by opening and closing the main door and then making a new selection.

3)Additional time can be purchased at any time. If the dryer is in operation (drying mode) and additional coins are inserted, the light emitting diode (L.E.D.) display will read the additional time for amount inserted.

2.Non-Coin (OPL) Dryers

The dryer is available for use when the L.E.D. display reads “FILL.” Once the load has been put into the dryer and the main door is closed, start the dryer as follows:

a.Determine fabric setting (selection). Setting “HIGH TEMP” is the high-temperature range, the “PERM PRESS” is the medium-temperature range, and the “LOW TEMP” setting is the low-temperature range.

b.Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the fabric setting key desired.

c.The dryer will now start, and the L.E.D. display for the basket (tumbler) selected will read the setting (selection) and the drying portion of the L.E.D. display will read “00” and count upwards in time.

d.Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will sound for 5-seconds, and the L.E.D. display will read “donE.”

NOTE: If theAnti-Wrinkle program is active, the L.E.D. display will remain reading “donE,” and the microprocessor controller (computer) will proceed through theAnti-Wrinkle program until the maximum “Active Guard Time” has expired or until the main door is opened, whichever comes first.

NOTE: If theAnti-Wrinkle program is not active or in use, the L.E.D. display will read “donE” until the main door is opened, at which time, the L.E.D. display will read “FILL.”

e.Notes

1)The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer, shut the main door and press desired setting.

NOTE: When a cycle is interrupted by opening the main door, the cycle time will continue to count upward, regardless if the door is open or closed until a keyboard (touch pad) selection is made.

2)Selection (setting) changes can be made at any time during the drying cycle by opening and closing the main door and then making a new selection.

34

Page 37 Page 39
Image 38
Page 37 Page 39
Contents ADG-530D II/WDA-530D Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check of Replacement Important Information Receiving and HandlingSafety Precautions What to do if YOU Smell GASPage Specifications SpecificationsSpecifications Installation Procedures UNPACKING/SETTING UPLocation Requirements Dryer Enclosure Requirements Fresh AIR Supply RequirementsPage Exhaust Requirements General Exhaust Ductwork InformationPage Page Page Page Page Page Page Page Page Page Important Venting Reminders Electrical Information Electrical RequirementsADG-530D Gas GAS Information Type of GAS Page Page Preparation for Operation Preoperational TestsPage Basket Tumbler Coating Operating Instructions Starting the DryerPage Shutdown Instructions Parts SERVICE/PARTS InformationService Warranty Warranty InformationReturning Warranty Cards Returning Warranty PartsPage Routine Maintenance CleaningAdjustments MonthsLubrication Troubleshooting SectionviiiFailed motor contactor/relay Microprocessor controller computer L.E.D. display reads dSFL Failed keyboard touch pad label assembly If dryer is equipped with optional battery backup Dryer operates, but is taking too long to dry Condensation on main door glass Datalabel LOCATION/INFORMATION Data LabelSerial Number Procedure for Functional Check Replacement Components
Top Page Image Contents