American Dryer Corp installation manual ML-55II Installation Manual

Page 1

ML-55II Installation Manual

Phase 7, Non-Coin

Warning: For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.

Do not store or use gasoline or other flam- mable vapors and liquids in the vicinity of this or any other appliance.

What To Do If You Smell Gas

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building or area of all occupants.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

Avertissement: Assurez-vous de bien suivre les instructions données dans cette notice pour réduire au minimum le risque d’incendie ou d’explosion ou pour éviter tout dommage matériel, toute blessure ou la mort.

Ne pas entreposer ni utiliser d’essence ni d’autres vapeurs ou liquides inflammables à proximité de cet appareil ou de tout autre appareil.

Que Faire Si Vous Sentez Une Odeur De Gaz

• Ne pas tenter d’allumer d’appareils.

• Ne touchez à aucun interrupteur. Ne pas vous servir des téléphones se trouvant dans le bâtiment.

• Évacuez la pièce, le bâtiment ou la zone.

• Appelez immédiatement votre fournisseur de gaz depuis un voisin. Suivez les instructions du fournisseur.

• Si vous ne pouvez rejoindre le fournisseur de gaz, appelez le service des incendies.

L’installation et l’entretien doivent être assurés par un installateur ou un service d’entretien qualifié ou par le fournisseur de gaz.

American Dryer Corporation

88 Currant Road

Fall River MA 02720-4781

Telephone: (508) 678-9000 / Fax: (508) 678-9447

e-mail:techsupport@amdry.com

www.amdry.com

ADC Part No. 113345

Image 1
Contents ML-55II Installation Manual Retain This Manual In a Safe Place For Future Reference Table of Contents Coil failure due to improper pH level will void Warranty Safety PrecautionsWhat to do if You Smell Gas 113345-9Specifications SPECIFICATIONS/COMPONENTComponent Identification Installation ProceduresLocation Requirements Dryer Front ViewDryer Enclosure Requirements Unpacking/Setting UpLeveling Dryer Allowances must be made For opening the control doorExhaust Requirements Fresh Air Supply RequirementsGeneral Exhaust Ductwork Information Horizontal VentingOutside Ductwork Protection Vertical VentingSingle Dryer Venting Hazard. The copper conductor wire/cable must be of proper When the exhaust ductworkPasses through a wall, ceiling Or roof made of combustibleSingle-Phase 1ø Wiring Connections/Hookup Electrical Service SpecificationsGas and Steam Models only Electric Models OnlyElectrically Heated Models Only Phase 3ø Wiring Connections/HookupGas Information Piping/Connections Steam InformationSteam Coil pH Level Steam Requirements High Pressure861.84 kPa Installation InstructionsSteam Damper Air System Connections Steam Damper Air Piston Flow Control Operation AdjustmentAir Requirements Air ConnectionPreoperational Tests Preparation For Operation/Start-UpShutdown Instructions Preoperational InstructionsWarranty Information SERVICE/PARTS InformationCleaning Routine MaintenanceAdjustments LubricationMicroprocessor Controller Computer Board Procedure for Functional Check of ReplacementFor Models with Fenwal Controls DSI Module Theory of OperationPhase Manual Reset Burner HI-LIMITDual Timer Data Label InformationFire Suppression System InstallationBefore You Start Water ConnectionsS. Theory Of Operation Electrical RequirementsTypical Water Supply Optional Manual Bypass S. Diagnostics System ResetS. Diagnostics Messages S. Water Valve CheckADC 113345 9 12/01/04-6