JVC KD-S741R, KD-S73R, KD-S71R, KD-S743R manual Maintenance, Handling discs

Page 26

MAINTENANCE

ENGLISH

Handling discs

This unit has been designed to reproduce CDs, CD-Rs (Recordable), and CD-RWs (Rewritable).

• This unit is not compatible with MP3 discs.

How to handle CDs

When removing a CD from its Center holder

case, press down the center holder of the case and lift the CD out, holding it by

the edges.

•Always hold the CD by the edges. Do not touch its recording surface.

When storing a CD into its case, gently insert the CD around the center holder (with the printed surface facing up).

•Make sure to store CDs into the cases after use.

To keep CDs clean

A dirty CD may not play correctly. If a CD does become dirty, wipe it with a soft cloth in a straight line from center to edge.

To play new CDs

New CDs may have some rough spots around the inner and outer

edges. If such a CD is used, this unit may reject the CD. To remove these rough spots, rub

the edges with a pencil or ball-point pen, etc.

Moisture condensation

Moisture may condense on the lens inside the CD player in the following cases:

•After starting the heater in the car.

•If it becomes very humid inside the car. Should this occur, the CD player may malfunction. In this case, eject the CD and leave the unit turned on for a few hours until the moisture evaporates.

When playing a CD-R or CD-RW

Before playing back CD-Rs or CD-RWs, read their instructions or cautions carefully.

•Use only “finalized” CD-Rs or CD-RWs.

•Some CD-Rs or CD-RWs may not play back on this unit because of their disc characteristics, and for the following reasons:

–Discs are dirty or scratched.

–Moisture condensation on the lens inside the unit.

–The pickup lens inside the unit is dirty.

•CD-RWs may require a longer readout time since the reflectance of CD-RWs is lower than that of regular CDs.

•CD-Rs or CD-RWs are susceptible to high temperatures or high humidity, so do not leave them inside your car.

•Do not use following CD-Rs or CD-RWs:

–Discs with stickers, labels, or protective seal stuck to the surface.

–Discs on which labels can be directly printed

by an ink jet printer.

Using these discs under high temperatures or high humidity may cause malfunctions or damage to discs. For example,

–Stickers or labels may shrink and warp a disc.

–Stickers or labels may peel off so discs cannot be ejected.

–Print on discs may get sticky.

Read instructions or cautions about labels and printable discs carefully.

CAUTIONS:

•Do not insert 8 cm CDs (single CDs) into the loading slot. (Such CDs cannot be ejected.)

•Do not insert any CD of unusual shape—like a heart or flower; otherwise, it will cause a malfunction.

•Do not expose CDs to direct sunlight or any heat source or place them in a place subject to high temperature and humidity. Do not leave them in a car.

•Do not use any solvent (for example, conventional record cleaner, spray, thinner, benzine, etc.) to clean CDs.

26

Warped

Sticker

Sticker

 

Stick-on

 

Disc

disc

 

residue

label

 

 

Page 25 Page 27
Image 26
Page 25 Page 27
Contents KD-S73R/KD-S71R/ KD-S743R/KD-S741R Position And Reproduction Of Labels How to reset your unitPrecautions Contents Display window Location of the ButtonsControl panel To turn off the power Turning on the powerTo drop the volume in a moment Basic OperationsSetting the clock Searching a station automatically Auto search Radio OperationsListening to the radio Searching a station manually Manual searchStoring stations in memory FM station automatic preset SSMWhen an FM stereo broadcast is hard to receive Tuning in to a preset station Manual presetTo use Network-Tracking Reception RDS OperationsWhat you can do with RDS Using TA Standby Reception To deactivate the TA Standby ReceptionUsing PTY Standby Reception To deactivate the PTY Standby ReceptionPress and hold TP/PTY for more than Station Seconds to exit from this modeTo store your favorite programme types Seconds while listening to an FMTo select any one of the twenty-nine PTY-codes To activate Programme search, follow the procedure belowTo select one of your favorite programme type Press ¢or 4 to start PTY search for your favorite programmeChanging the display mode while listening to an FM station Setting the TA volume levelAutomatic clock adjustment PTY codes Same programme can be received on different frequenciesTo stop play and eject the CD CD OperationsPlaying a CD Insert a CD into the loading slotTo go to a particular track directly To fast-forward or reverse the trackTo go to the next or previous tracks To play back tracks at random Random PlayTo play back tracks repeatedly Repeat Play To cancel the prohibition and unlock the CDProhibiting CD ejection While pressing CD, press and hold 0for more than 2 secondsAdjust the setting Sound AdjustmentsAdjusting the sound Select the item you want to adjustRepeat the same procedure to store other sound modes Storing your own sound adjustmentsCall up the sound mode you want to adjust Select BAS bass, TRE treble, or Loud loudnessSelect Level Select the desired mode-VOL 1, VOL 2, or OFF Other Main FunctionsSelecting the telephone muting Preferred Setting Mode PSM items 24H/12HDetaching the control panel Attaching the control panelTroubleshooting Symptoms Causes RemediesMaintenance Handling discsUsable Sensitivity SpecificationsFM Tuner MW TunerHaving Trouble with operation? Before mounting Press Voordat u aan de montage van het apparaatFuse blows HinweisRemarque No sound from the speakersRear ground terminal Hintere Erdungscanschlu ßklemme Sicherstellen, daß das Gerät am Fahrwerk geerdet wirdOpmerking Borne arrière de MasseKD-S743R Les extrémités de ces fils inutilisés avec de laBande isolante comme montré ci-dessus KD-S741R
Top Page Image Contents