Installation
This instruction manual should be kept in a safe
GB | place for future reference. If the washing machine is |
| |
| sold, transferred or moved, make sure that the |
| instruction manual remains with the machine so that |
| the new owner is able to familiarise himself/herself |
| with its operation and features. |
| Read these instructions carefully: they contain vital |
| information relating to the safe installation and |
| operation of the appliance. |
| Unpacking and levelling |
| Unpacking |
| 1. Remove the washing machine from its packaging. |
| 2. Make sure that the washing machine has not been |
| damaged during the transportation process. If it has |
| been damaged, contact the retailer and do not |
| proceed any further with the installation process. |
| 3. Remove the 4 |
| protective screws (used |
| during transportation) and |
| the rubber washer with |
| the corresponding |
| spacer, located on the |
| rear part of the appliance |
| (see figure). |
4.Close off the holes using the plastic plugs provided.
5.Keep all the parts in a safe place: you will need them again if the washing machine needs to be moved to another location.
Packaging materials should not be used as toys for children.
Levelling
1.Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or anything else.
2. If the floor is not perfectly level, compen- sate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured in relation to the worktop, must not exceed 2°.
Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washing machine.
Connecting the electricity and water supplies
Connecting the water inlet hose
1. Connect the supply pipe by screwing it to a cold water tab using a 3/4 gas threaded connection (see figure).
Before performing the connection, allow the water to run freely until it is perfectly clear.
2. Connect the inlet hose to the washing machine by screwing it onto the corresponding water inlet of the appliance, which is situated on the top right- hand side of the rear part of the appliance (see figure).
3. Make sure that the hose is not folded over or bent.
The water pressure at the tap must fall within the values indicated in the Technical details table (see next page).
If the inlet hose is not long enough, contact a specialised shop or an authorised technician.
Never use
Use the ones supplied with the machine.
2