Maytag MDE 9801, MDE 9701 manual Tip, 9AFTER Tumble Drying

Page 14

The filter may require cleaning if lime scale deposits are present; see Chapter 10, Care and Cleaning.

Draining the condensation water container

The condensation water container must be emptied after each tumble drying.

Pull out the condensation water container, drain any water

and replace the

container. If the condensa-

tion water contai-

ner becomes too full, the programme will be

interrupted and

will appear in the display.

Drain the container and press the

but-

ton, and the programme will now continue from where it was interrupted; see also Chapter 11, Trouble shooting, heading Fault indications.

NOTE

Do not pull out the condensation water contai- ner while the tumble dryer is running.

TIP

The condensation water is soft, which makes it suitable for use in a steam iron. Strain the water through a coffee filter before use.

Automatic emptying

See the Installation instructions if you prefer the water to be emptied automatically.

9AFTER TUMBLE DRYING

Turn off the main switch .

Take out the clothes, and close the door to prevent small children from crawling into the machine.

14

Image 14
Contents Maytag Contents Do not TUMBLE-DRY Before Tumble Drying the First TimeRead the Operating Instructions Safety Instructions CHILDREN’S Safety Child Lock on ButtonParts of the Tumble Dryer Panel Option ButtonsRecommended Washing Marking Before Tumble DryingSPIN-DRIED? Sorting FabricsProgrammes OptionsTemperature Drying Time Select a Programme Tumble DRY 1SORT Fabrics 5SET the Time for AIR Fluff and Timed DRY ProgrammesDelayed start 7START the Drying Programme with ButtonDuring the Drying Programme 8DRYING Programme EndedTIP 9AFTER Tumble DryingConsumption Values Programme TimeCleaning the Outside of the Machine Care and CleaningCleaning the Lint Filter Emptying the Condensation Water Contai NERCleaning the FAN Unscrew the nut while holding the fanCleaning the Condenser This page has been left blank for technical printing reasons Overheating Protection Trouble ShootingMachine will not Start Excessive Drying TimeFault Indications on the Display Normal Indications on the DisplayThis page has been left blank for technical printing reasons Standard Tests Technical DataTechnical Information This page has been left blank for technical printing reasons Guarantee Service and GuaranteeService Quick Guide DoorIndex Chapter