Maytag MDE 9701, MDE 9801 manual CHILDREN’S Safety, Child Lock on Button

Page 5

3 CHILDREN’S SAFETY

GENERAL

Do not allow children to play with the tumble dryer.

The tumble dryer is fitted with a magnetic catch, which allows the door to be opened from the inside. The door is equipped with a switch, which automatically stops the tumble dryer when the door is opened. The machine will not start automatically on closing the door (eg, if a child should close the door from the inside).

CHILD LOCK ON BUTTON

You can prevent a child from starting the tum- ble dryer by mistake. You can do this by locking

the button, as follows.

Child lock On/Off:

Set the programme selector knob to the posi- tion in which it points directly upwards.

Turn off the main power switch and then turn it on again so that the machine is in stand-by mode.

Press the button five times, and then

press the button five times. These ten pres- ses must be completed within 15 seconds.

Within three seconds after pressing the button for the last time, you must then use the

button to select Child lock On (the figure 3 appears in the display) or Off (the figure 0 appears in the display).

Start a programme with the button locked:

To start the machine, you must hold the button down for three seconds.

5

Image 5
Contents Maytag Contents Do not TUMBLE-DRY Before Tumble Drying the First TimeRead the Operating Instructions Safety Instructions Child Lock on Button CHILDREN’S SafetyParts of the Tumble Dryer Option Buttons PanelSPIN-DRIED? Before Tumble DryingRecommended Washing Marking Sorting FabricsOptions ProgrammesDrying Time Temperature1SORT Fabrics Tumble DRYSelect a Programme 5SET the Time for AIR Fluff and Timed DRY Programmes7START the Drying Programme with Button Delayed start8DRYING Programme Ended During the Drying Programme9AFTER Tumble Drying TIPProgramme Time Consumption ValuesCleaning the Lint Filter Care and CleaningCleaning the Outside of the Machine Emptying the Condensation Water Contai NERUnscrew the nut while holding the fan Cleaning the FANCleaning the Condenser This page has been left blank for technical printing reasons Machine will not Start Trouble ShootingOverheating Protection Excessive Drying TimeNormal Indications on the Display Fault Indications on the DisplayThis page has been left blank for technical printing reasons Standard Tests Technical DataTechnical Information This page has been left blank for technical printing reasons Guarantee Service and GuaranteeService Door Quick GuideChapter Index