FAULT INDICATIONS
Error messages appear in the display text field if faults occur while a programme is in progress. To exit the error messages after correcting the fault as described below, switch the machine off or change the programme.
The error messages that can be displayed are:
Maximum programme time. When the mach- ine has run for its maximum time (three hours) it will stop. Ensure first that all fuses for the machine are intact. To exit the error message, switch the machine off or open the outer door. If this does not help, phone for service.
Over flow. Indicating that the condensation wa- ter container is overfilled. Empty the container and restart. If the message is repeated it may be because the lower water magazine is full, due to the pump or hoses being clogged or malfunctio- ning. If condensation water is pumped out di- rect to the drain, check to ensure there are no kinks or stoppage in the hose. If this does not help, phone for service.
Sensor fault. Fault in the moisture sensor. This error message can also appear if you should start the dryer when it contains dry items or when it is empty. To cancel the message, simply open the dryer door. If this does not work, phone for service.
Thermistor fault. Phone for service.
WRONG LANGUAGE ON THE DISPLAY
If the language on the display becomes altered for any reason, it can be restored to the initial language again.
The available languages are Eng (AUS), Svenska, Dansk, Norsk, Suomi, Francais, Ne- derlands, Italiano, Espanol, Russia, Deutsch, Eng (US).
Proceed as follows to change the language:
Turn the main power switch, 
, of and then turn it on again. Press the Enter button five times, then press the P1 button five times. These ten times must be completed within fif- teen seconds.
Within three seconds after pressing P1 the last time, step to the desired language using the
27