ENGLISH
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1 Select the item you want to adjust.
Each time you press the button, the adjustable items change as follows:
For KD-AR600:
*1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode
*2 If you are using a
*3 Only for
This takes effect only when a subwoofer is connected.
*4 Normally the control dial work as the volume control. So you do not have to select “VOL” to adjust the volume level.
*5 Depending on the amplifier gain control. (See page 28 for details.)
BAS | TRE | FAD | BAL | 2 Adjust the setting. | |
(bass) | (treble) | (fader) | (balance) | ||
VOL | SUB.W | LOUD |
| ||
(volume) | (subwoofer) | (loudness) | To increase the level or | ||
For |
|
|
| turn on the loudness | |
|
|
|
| ||
BAS |
| TRE | FAD | To decrease the level or | |
(bass) | (treble) | (fader) | turn off the loudness | ||
VOL | LOUD | BAL | |||
| |||||
(volume) | (loudness) | (balance) |
|
Indication | To do: |
| Range |
|
|
| |
BAS*1 | Adjust the bass. | ||
|
|
| |
|
| +06 (max.) | |
|
|
| |
TRE*1 | Adjust the treble. | ||
|
|
| |
|
| +06 (max.) | |
|
|
| |
FAD*2 | Adjust the front | R06 (Rear only) | |
| and rear speaker |
| |
| balance. | F06 (Front only) | |
|
|
| |
BAL | Adjust the left | L06 (Left only) | |
| and right speaker |
| |
| balance. | R06 (Right only) | |
|
|
|
|
LOUD*1 | Boost low and |
|
|
| high frequencies | LOUD ON | |
| to produce a well- | ||
|
| ||
| balanced sound |
| |
| LOUD OFF | ||
| at low volume | ||
|
|
| |
| level. |
|
|
|
|
|
|
SUB.W*3 | Adjust the | 00 | (min.) |
(only for | subwoofer |
| |
output level. | 08 | (max.) | |
|
|
|
|
VOL*4 | Adjust the volume. | 00 | (min.) |
|
|
| |
|
| 30 or 50 (max.)*5 | |
|
|
|
|
Indication pattern changes as you adjust the bass or treble.
Ex. 1: When you adjust “TRE” (treble)
Ex. 2: When you turn on the loudness
3 Repeat steps 1 and 2 to adjust the other items.
To reset each sound mode to the factory
settings, repeat the same procedure and reassign the preset values listed in the table on
page 23.
24