Maytag MCE8000AY Electrical Service Information, About Ground Wires, Gas Connection Information

Page 5

Important Safety Information

!WARNING

The California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65) requires the Governor of California to publish a list of substances known to the State of California to cause cancer or reproductive harm and requires business to

warn consumers of potential exposures to such substances.

Users of this appliance are hereby warned that the burning of gas can result in low-level exposure to some of the listed substances, including benzene, formaldehyde and soot, due primarily to the incomplete combustion of natural gas or liquid petroleum (LP) fuels. Exhaust ducts should be kept free of obstructions and properly exhausted dryers will minimize exposure.

Electrical Service Information

Electrical Dryers

240 VAC, 60 Hz, 30 Amps, 3–wire or 4–wire installations

Gas Dryers

• 120 VAC, 60 Hz, 20 Amps, 3–wire installations

About Ground Wires

In the event of an electrical short circuit, a ground wire reduces the risk of electric shock by providing an escape wire for the electric current.

Standard accepted color coding for ground wires is green or green with a yellow stripe.

Grounding wires and wires colored like grounding wires are NOT to be used as current carrying conductors.

!WARNING

To reduce the risk of fire, electric shock, serious injury or death, all wiring and grounding must conform with the latest edition of the National Electric Code, ANSI/ NFPA 70, or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer’s responsibility to have the wiring and fuses checked by a qualified electrician to make sure your home has adequate electrical power to operate the dryer.

!WARNING

To avoid risk of personal injury or death due to electrical shock:

Observe all local codes and ordinances.

Disconnect electrical power to unit before servicing.

Ground appliance properly.

Check with a qualified electrician if you are not sure this appliance is properly grounded.

DO NOT ground to gas line.

DO NOT ground to cold water pipe if pipe is interrupted by plastic, non-metallic gaskets, or other insulating (non-conducting) materials.

DO NOT modify plug on power cord. If plug does not fit electrical outlet, have proper outlet installed

by qualified electrician.

DO NOT have a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit could result in an electrical shock.

DO NOT use an extension cord with this appliance.

DO NOT use an adapter plug with this appliance.

DO NOT pinch power cord.

Gas Connection Information

!WARNING

To avoid death, personal injury or property damage, from fire or explosion, information in this manual must be followed exactly.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

!WARNING

To reduce the risk of fire and exposure to combustion gases, the dryer MUST be exhausted to the outdoors. DO NOT exhaust dryer air into a window well, gas vent, chimney or enclosed, unventilated area, such as an attic, wall, ceiling, crawl space under a building or concealed space of a building.

©2003 Maytag Appliances Company

16022785 Rev. 0

5

Image 5
Contents Neptune DC Web Site Telephone Number Customer Service Support CenterRecognize Safety Symbols, Words, and Labels Table of Contents Important Safety Information About Ground Wires Electrical Service InformationGas Connection Information Electrical DryersImportant Safety Information Altitude Orifice Part Ft M Size # Number Testing for Gas LeaksGas Connection Parts and Accessories ServiceExtended Service Plan PropaneDrying Center Nomenclature E 8 0 0Drying Center Specifications Will Not Run Maytag Neptune Drying CenterWill not start or run Will Not Dry Gas ModelsSystem Check Mode Troubleshooting the Sensor-Dry circuitNoisy and/Or Vibration Rd**Read Sensor InputsDL****Accessing Diagnostic Codes Diagnostic CodesSensor Display Menu Sc***Upper and Lower Dryer Sub-system Check UtilitiesCode Description Trigger Action Taken Diagnostic Codes RS Reset to Factory Default ConditionsCancel the Read Sensor Display Function Enter The Diagnostic Utilities MenuCodes Visible To The Consumer CS******View Cycle StatisticsLocation Description Plug Number Pin Number Membrane Pad Continuity ChecksJ1A Name Relay Header Connections Connector DescriptionDoor Hook Removal Lower Door Reversal/RemovalShaker Removal Console Removal Logic Board Removal Front Access Panel RemovalDisassembly Procedures Tumbler Drum Removal Heater Assembly Removal Blower and Motor Removal Relay Board RemovalSteamer Blower Removal Water Valve RemovalSteamer Heater Removal Appendix a Maytag Appliances Company 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev Appendix B Maytag Appliances Company 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev 16022785 Rev