INSTALLATION INSTRUCTIONS
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
|
|
|
| Wood block | |
|
|
|
|
|
|
Wire stripper (direct wire |
| Tin snips (new vent |
installations) |
| installations) |
|
|
|
|
|
|
1/4" (7 mm) nut driver |
| Adjustable wrench that |
(recommended) |
| opens to 1" (25 mm) or |
|
| |
|
|
|
|
|
|
Level | Caulking gun and |
| |
| compound (for installing |
| new exhaust vent) |
Parts needed: (Not supplied with dryer) Vent clamps
Vent elbows and ductwork
Additional parts may be required, depending on your installation. Check local codes. Check existing electrical supply and venting. Read “Electrical Requirements” and “Venting Requirements” before purchasing parts.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain:
nA UL listed
the dryer must end in ring terminals or spade terminals with upturned ends.
nA UL listed strain relief.
Parts supplied:
Parts package is located in dryer drum. Check that all parts are included.
NOTE: Do not use leveling legs supplied if installing with a pedestal or a stack kit.
Coupling
Options: (Not supplied with dryer)
Pedestal
You may order a pedestal separately for this dryer. This pedestal will add about 12" (305 mm) to the height of your unit
for a total height of approximately 45" (1.14 m).
To order, call the dealer from whom you purchased your dryer
or refer to the “Assistance or Service” section of this manual. Ask for Model Number LAB0050PQ.
| Stack kit | |
| Are you planning to stack your washer and dryer? Your dryer is | |
| shipped with Stack Kit W10178021, which fits Maytag washer | |
| models starting with MHWC. | |
Torx® T20 screwdriver | If you have any other washer model, call the dealer from whom | |
you purchased your dryer or refer to the “Assistance or Service” | ||
| ||
| section of this manual. |
® TORX is a registered trademark of Saturn Fasteners, Inc.
9