Before Using
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation |
|
position of the drain hose. | Soft item |
|
Extend the drain hose from the side of spin tub
Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabinet. Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the side Soft item of the spin tub in the order of (1)~(3), heading for the
side of the spin tub. (See to Figure 3).
Embed the drain hose into the groove with hands. Take care not to damage the drain 
hose in fastening the fixing clamp.
Extend to the spin tub side
Extend the drain hose from the rear side
Back
Front
Figure 1
Figure 2
Embed into the
groove in turn Figure 3
Take out the drain hose from the fixing groove. Extend it from the rear side as per the direction of the arrow. (When the drain hose is extended from the rear side, it can be hung on the point for drain hose at the two sides of the cabinet.) (See to Figure 4).
Figure 4
Install the water inlet hose; Select the water level
Insert the water inlet hose into the | Water inlet hose |
|
|
|
|
| |
entrance on the control panel, then push the |
| Water | inlet jointer |
|
|
| |
control panel. (To dismantle the water inlet pipe, | Push | Water | inlet |
just push the control handle as indicated in the | Control handle | ||
figure and pull it out) |
|
|
|
Select water level according to the quantity of the laundries.
Set the water level adjusting lever to needed line.
Page8
Water level indicator
Maximum Max
about 43L
Med
Medium 
about 36L | Min | |
Minimum | ||
| ||
about 30L |
|