Humminbird LCR120 manual

Page 18

www..reelschel matic..com

Optional: If the cables pass outside the mounting bracket, install the hole cover over the hole and fasten in place using the two #8 x 7/8” (22mm) wood screws (Figure 24).

Image 18
Contents Page Accessories Installation OverviewParts Supplied Determining How to Mount the Transducer Trolling Motor Mounting Alternate Transducers and Mounting MethodsPortable Mounting Thru-Hull MountingBeginning Installation Transducer ExchangeTransom Installation Step One Determine Where to Mount the TransducerStep Two Drill the Mounting Holes Step Three Assemble the TransducerPage Step Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomConfirm the pivot angle has not changed Page Step Six Route the Cable Inside the Hull Installation Step One Determine the Mounting LocationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Control Head Installation Step One Determine Where to MountStep Two Connect the Power Cable to the Boat Page Step Three Drill the Mounting Holes Step Four Run the CablesPage Step Five Assembling the Connector Holder Your Humminbird is now ready for operationTest the Installation Testing the Installation Mounting the LCRUsing the LCR Using the Built-In SimulatorLCR 120 Functions LCR 120 FunctionsFactory Setting Fish symbols Units SensitivityBottom Alarm Fish AlarmZoom Bottom Lock Using Bottom Lock Factory Setting Off Display Speed Setting Display Speed Depth Range Setting Depth RangeTrip Log