Humminbird Portable Attaching the Control Head, Assembling the Transducer Mount, Bolt Wing nut

CASE ASSEMBLY

ATTACHING THE CONROL HEAD / ASSEMBLING THE TRANSDUCER MOUNT

Attaching the Control Head

Thumb knob

Battery Compartment

1. Remove the pivot bolt, gimbal knob, and rub-
ber washers from the hardware bags.	Gimbal knob

2. Place the rubber washers between the control head’s pivot knuckle and the arms from the portable case. Make sure that the control head screen is facing the case.

3.Slide the pivot bolt through the left side and screw the gimbal knob onto it using only 2-3 turns. The gimbal knob has two alignment pins that will seat into holes in the case arm holding the Piranha control head. Make sure these pins are seated and then tighten the assembly to a snug tension.

Cable Holes

Suction Cup

	Plastic Bracket
Star Lock	Phillips
Washers
	Head
Phillips	Bolt
Head	Washer &	Star Lock
Bolt	Wing nut
		Washers

Cable Clip

Washer &

Wing nut

Bolt

Transducer

Piranha 1 thru 4 Transducer Piranha 5 and 5x Transducer

Assembling the Transducer Mount

Note: Depending on your transducer type, you will use only one of the two mounting brackets included (see illustrations).

1. With a #2 Phillips screwdriver, attach the suction cup to the mounting bracket using the ¹⁄₄-20 x ³⁄₄" machine screw. Hand tighten only; do not use power tools.

2. Connect the transducer body to the mounting arm using a #2 Phillips screwdriver and the hardware shown. Hand tighten only; do not use power tools.

3