Humminbird Portable manual Maintenance and Warranty, Replacing the Battery Power Cable

Page 10

MAINTENANCE AND WARRANTY

MAINTENANCE / REPLACING THE BATTERY POWER CABLE

MAINTENANCE

Your Humminbird Portable fishfinder is designed to provide years of trouble-free operation with virtually no maintenance. Follow the simple procedures below to ensure that your Humminbird Portable continues to deliver top performance.

If you are storing the Portable case for an extended period of time, it is best to remove the bat- teries from the case in case of leakage.

If the Portable case comes into contact with salt spray, simply wipe the affected surfaces with a cloth dampened in fresh water.

Never leave your Humminbird Portable unit in a closed car or trunk - the extremely high tem- peratures generated in hot weather can damage the electronics. Repairs should be performed only by authorized Humminbird technicians.

Replacing the Battery Power Cable

Note: You will not have to install the battery power cable before first use, but may need to replace it should it become corroded after prolonged usage in a marine environment.

1.

Flip open the rubber cable cover/retainer on the back of the case by pulling on the

 

tab located at the upper left corner.

¹⁄₄” Hex drive nuts

2.

Make sure the transducer

 

 

 

 

cable is totally removed

Negative

Positive Lead

 

from the cable channel,

 

 

 

Lead

 

 

detach the power cable

 

 

 

 

 

from the control head

 

 

 

and pull the power cable

 

 

 

through the power cable

 

 

 

hole.

 

 

3.Using a ¹⁄₄” hex driver,

 

unscrew the battery cable

Cable Route

 

ends from the positive and

 

 

negative studs.

 

4.

Clean the studs if they are

 

 

corroded.

Cut-a-way view of battery leads.

5.To install a new power cable, place the red wire on the positive stud and the black wire on the negative stud.

8

Image 10
Contents R T a B L E Thank YOU Table of Contents Piranha Portable Case Assembly Case AssemblyCase Assembly Overview Assembling the Transducer Mount Thumb knob Battery CompartmentAttaching the Control Head Ber washers from the hardware bagsWind the transducer cable around the cable channel Attaching the Transducer CablePlug the transducer cable into the back of the control head Rubber Cable CoverIntroduction to Mounting Installing the BatteriesMounting the Transducer Surface Mount Mounting the CaseMounting the Case Surface mount not included Nylon web strap not includedThrough strap Surface mounting using strapsRemoving the Case After USE Transducer CableMaintenance Maintenance and WarrantyReplacing the Battery Power Cable Techsonic INDUSTRIES’ 1-YEAR Limited Warranty Service POLICY/ Customer Resource Center Service Policy 248mm H x 159mm W x 127mm D SpecificationsVersatile options, from quick disconnect to web strap