CASE ASSEMBLY
ATTACHING THE TRANSDUCER CABLE
Attaching the Transducer Cable
1.Flip open the rubber cable retaining cover on the back of the case by pulling on the tab located at the upper left corner.
2.Thread the end of the transducer cable through the transducer cable hole which is located on the back of the case (see illustration).
3.Plug the transducer cable into the back of the control head.
4.Turn the case so that you are look- ing at the front, and make sure there is enough slack in the trans- ducer cable, then push it into the transducer cable clip on the left (see illustration).
5.Wind the transducer cable around the cable channel.
Holes for Power Cable and Transducer Cable Routing
Mounting clips for Permanent Mounting bracket and Storage for Suction Cup
Rubber
Cable
Cover
6.When finished winding, clip the cable on one of the two indentions located on either side of the case.
7.Push down on the cable cover to conceal the cable.
8.Attach the suction cup transducer assembly to the back of the case by pinching the suction cup on both sides and allowing it to snap into the universal mount. (This universal mount also acts as a surface mount attachment. See the Surface Mount section for more information.)
Cable Clip detail
Cable Clip
4