Topcom 3800 Getting started, Charging batteries, Removing/Installing the Belt Clip

Topcom Twintalker 3800

9Getting started

A

B

	D	E
	-		+	-
C	1		AAx1	1xAA
	x
	AA
		+	-	+

10 Charging batteries

9.1Removing/Installing the Belt Clip

1.To remove the belt clip from the unit, push the belt clip (B), while pulling the clip away from the unit (A).

2.To install the belt clip, align the pin with the hole in the backside. Gently push until it clicks into position.

9.2Battery Installation

1.Remove the belt clip (See chapter 9.1.1).

2.Pull the battery cover tab (C) and gently remove the battery cover (D).

3.Install the enclosed 3 x AA NiMh batteries following the polarity as shown (E).

4.Re-install the Battery Cover and Belt Clip (See chapter 9.1.2).

15

When using rechargeable batteries you can use an optional adapter to charge.

•Insert three (3) “AA” rechargeable batteries.

•Plug the small plug of the adapter into the SPK/ MIC/CHG jack (15) and the other end in the electrical socket.

•Make sure that the unit is switched off in order to charge the batteries properly.

NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.

Only use the enclosed AC/DC ADAPTER with “AA” rechargeable batteries. Do not charge this unit when regular “AA” alkaline batteries are installed!

4 Topcom Twintalker 3800