Humminbird Portable Removing the Case After USE, Through strap, Surface mounting using straps

Page 9
Power Cable
Control Head

MOUNTING THE CASE

NYLON WEB STRAP / REMOVING THE CASE AFTER USE

7.Press the center section and then twist the Piranha Portable case until it is facing you. Six clicks produces maximum clamping and aligns the control head.

8.For fine-tuning, remove the Piranha Portable case and loosen the two screws. Rotate the surface mount and retighten the screws.

Nylon Web Strap (not included)

There are multiple ways in which to strap your Piranha Portable to your fishing platform:

1.Friction grooves, located on the left and the right of the Piranha Portable case, are specially designed to grip a standard

¹⁄₂ to 2 inch nylon web strap. With the control head up you can make use of the friction grooves by wrapping the nylon web strap around the case.

Cross strap for Kayaks and similar craft.

Through strap

for boat seats Top of permanent mounting

or tubes area,(press slightly to engage Permanent Mounting Clip.

Surface mounting using straps

2.Other ways of strapping that make use

of a ¹⁄₂-inch nylon web strap that is positioned across the suction cup retainer bridge, (see illustration above). This is useful when strapping to a seat or tube.

REMOVING THE CASE AFTER USE

1.With the boat engine off, loosen all cable retainers/clips holding the transducer.

2. Remove the case from the surface mount.

3. Remove the transducer from the surface where it has been mounted.

4. Turn the case over, flip open the rubber cable

Transducer Cable

retainer by pulling on the tab located at the upper left corner, and wrap the cable back into the cable run, then push the cable under the outer cable clip.

5. If you will not be using the unit again in

the near future, remove the batteries to Thumbknob prevent corrosion, and store.

Pivot Knuckle

Piranha Portable Ready to travel

7

Image 9
Contents R T a B L E Thank YOU Table of Contents Case Assembly Piranha Portable Case AssemblyCase Assembly Overview Attaching the Control Head Thumb knob Battery CompartmentAssembling the Transducer Mount Ber washers from the hardware bagsPlug the transducer cable into the back of the control head Attaching the Transducer CableWind the transducer cable around the cable channel Rubber Cable CoverInstalling the Batteries Introduction to MountingMounting the Transducer Mounting the Case Mounting the CaseSurface Mount Surface mount not included Nylon web strap not includedRemoving the Case After USE Surface mounting using strapsThrough strap Transducer CableMaintenance and Warranty MaintenanceReplacing the Battery Power Cable Techsonic INDUSTRIES’ 1-YEAR Limited Warranty Service POLICY/ Customer Resource Center Service Policy Specifications 248mm H x 159mm W x 127mm DVersatile options, from quick disconnect to web strap