Humminbird AS GR4 manual Start-Up Options Menu, Normal Operation

Page 11

User Mode (Normal or Advanced) - An Advanced Mode is provided for users who desire the highest level of control over the Matrix Fishing System and Normal Mode for users who desire greater simplicity and fewer menu choices. Additional Advanced menu choices will be displayed throughout the menu system when you navigate to specific menus while in Advanced Mode. Any changes made while in Advanced Mode will remain in effect after you switch back to Normal Mode. For example, if you set specific views to be visible while in Advanced User Mode, and then return to Normal User Mode, those views will still be visible. See Setup Menu Tab: User Mode for specific instructions on changing to Advanced User Mode.

Sonar Tab, Normal Mode

Sonar Tab, Advanced Mode

Total Screen Update - when you change any menu settings that affect the Sonar View, the view will update immediately (i.e. you don’t have to exit the menu to apply the change to the screen). For instance, by switching between "Inverse" and "Structure ID®" from the X-PressTMmenu it is possible to alternate quickly between the two viewing methods.

 

Start-Up Options Menu

 

Press the MENU key when the Title screen is displayed to

 

access the Start-Up Options menu.

 

Use the UP or DOWN 4-WAY Cursor keys to position the

 

cursor, then the RIGHT Cursor key to select one of the

 

following choices. If you wait too long, the system will

 

default to whichever menu mode happens to be

 

highlighted:

 

• Normal

 

• Simulator

Start-Up Options Menu

 

• System Status

 

• PC Connect (use with PC Connect Cable).

See the following paragraphs for more information about each of these choices.

Normal Operation

Use Normal operation for on the water operation with a transducer connected. In addition, your Matrix Fishing System uses advanced transducer detection methods to determine if a transducer is connected. If a functioning transducer is connected, Normal operation will be selected automatically at power up and your Matrix Fishing System can be used on the water.

Exit Normal operation by powering your Matrix Fishing System off.

16

17

Page 10 Page 12
Image 11
Page 10 Page 12
Contents GR4 GPS Receiver Accessory Manual Thank You Table of ContentsHow GPS Works GR4 GPS Connection KitIf you have… Then use Connecting a GR4 GPS Receiver to the MatrixAccess under mounting location No access under mounting locationFollow these steps to stem mount the GPS receiver Access Under Mounting LocationStem Mount with 1 14 Thread Finish Routing the Cable and Check Operation No Access Under Mounting LocationViews Bird’s Eye ViewCombo View Track ViewCombo View View OrientationWaypoints, Routes and Tracks Introduction to NavigationWaypoints, Routes and Tracks Save, Edit, or Delete a WaypointTrack View with Grid Navigate to a Waypoint or PositionAdd a Waypoint Target or Trolling Grid Save or Clear a Current TrackMenu System Edit, Delete or Hide Saved TracksNormal Operation Start-Up Options MenuWith PC Connect Cable Only Self Test Accessory TestSimulator System StatusZoom Sonar X-PressTMMenuMark Navigation X-PressTMMenuClear Current Track Cancel NavigationGo To Save Current TrackTracks Remove GridSonar Window Navigation Menu TabTrackpoint Interval WaypointsNorth Reference Grid RotationDelete All Nav Data Alarms Menu Tab Map DatumOff Course Alarm Track Min DistanceDrift Alarm Setup Menu TabArrival Alarm Local Time Zone Triplog ResetUnits Distance Units SpeedNmea Output Position FormatTime Format Date FormatProblem TroubleshootingDisplay Problems Fishing System Doesn’t Power UpBoat’s engine Matrix Fishing System AccessoriesFinding the Cause of Noise Possible Source of Noise Isolation Other electronic devicesContact Humminbird
Top Page Image Contents