Humminbird 343c manual Receiver See Transmitter

Page 34

531447-1_A_343c_Eng.qxd 11/11/2005 9:18 PM Page 66

provide the ability to spot fish and structure over a wide 90° area, and to identify on which side of the boat they are located. See DualBeam PLUS™.

Quick Disconnect Mount: The Quick Disconnect Mounting system is an exclusive Humminbird® feature that permits the unit to be easily removed from the mounting base by pressing a release button, and re-installed by simply snapping it back into place. All cable connections are made when installing, so that no separate wiring connections are required. Additionally, the mount offers 90° tilt and 360° swivel capability to adjust the viewing angle of the unit as you move about the boat.

Real Time Sonar: Real Time Sonar is a Humminbird® technology that delivers ultra- fast sonar transmitter/receiver operation and results in a more detailed instantaneous view of what is under the boat. The Real Time Sonar window is a vertical band at the right side of the display that shows the instantaneous sonar return from the transducer at a particular instant. The RTS® Window menu option permits the user to adjust the window to show the full sonar signal return, or just a narrower band that indicates intensity using grayscale. Real Time Sonar relies on very fast Sonar Update Rate (Ping Speed). See Sonar Update Rate.

Receiver: See Transmitter.

Second Return: The Second Return is a term that describes the appearance of a second sonar return below the primary sonar return (bottom contour) at exactly twice the true depth. The second return is caused by the same sonar energy bouncing off the bottom once, rebounding to the water surface and then traveling back down to the bottom to be reflected again. Second returns are more common in shallow water and over hard bottoms; it is actually possible to see a third sonar return under some circumstances. The second return provides useful information to help determine bottom hardness, as areas with harder bottoms will generally create a second return. The second return can be used as a guide to set Sensitivity when in shallower water.

Sensitivity: Sensitivity is a user feature that adjusts the sensitivity of the sonar system to show more or less detail in the water. Higher sensitivities are often preferred; however, when the water contains debris (silt, storm debris, etc.) it can be difficult to pick out targets. Conversely, if sensitivity is set too low, relevant targets may be missed.

SONAR: SONAR is the acronym for SOund and NAvigation Ranging. Sonar technology uses precision sound bursts transmitted underwater to determine the distance and other attributes of objects in the water. Distance can be determined because the speed of sound in water is constant, and the time for the signal to return is measured. Sound also travels very quickly underwater, making sonar a responsive, cost-effective tool. Sonar is the basic technology behind all recreational and commercial fishfinding and depthfinding devices.

Sonar Echo Enhancement: Sonar Echo Enhancement is a Humminbird® feature that describes the high degree of sonar sensitivity achieved through a combination of transmitter/receiver and software algorithms. The result of Sonar Echo Enhancement is to display virtually everything in the water that is of interest to the angler, including bait fish, game fish, thermoclines, weed beds, subtle structure, and more.

Sonar Update Rate: Sonar Update Rate is the number of times per second that the transmitter/receiver sends and receives sonar signals. A very fast sonar update rate collects more information and provides a more detailed image of the bottom, fish and structure. Many Humminbird® units operate at up to 40 times per second when in single frequency operation. Due to the limitation of the speed of sound in water, the update rate begins to slow as depth increases to deeper than 50 feet. In very shallow water (less than 10 feet), however, update rates as much as 60 times per second can be achieved.

Speed: Speed is the rate at which the boat moves through the water. Boat speed can be measured as Speed Over Ground or Speed Through Water. Speed Over Ground is provided by GPS, and is the measurement of the boats progress across a given distance. Speed Through Water is provided by a speed paddlewheel, and is the measurement of the flow past the boat, which may vary depending on current speed and direction. Speed Through Water is most critical for anglers using downriggers, as it impacts the running depth of the down riggers. Speed Over Ground is optimal for navigation, as accurate destination times can be derived from this measurement. Humminbird® products allow for input and display of both sources.

Structure: Structure is a general term for objects on the bottom that present a discontinuity and are a likely attractor for fish. This includes bottom contour features (drop-offs, humps, and holes), standing structure (stumps, timbers, brush piles) and a wide range of other potential objects (sunken boats, reefs). Humminbird® units excel at showing structure with great detail over a wider area due to unique sonar configurations developed for the angler.

61

62

Image 34
Contents 343c Operations Manual Table of Contents Thank YouTroubleshooting Alarms Menu TabSetup Menu Tab Specifications Glossary Contact HumminbirdHow Sonar Works DualBeam Plus Sonar What’s On the Display High Sonar Intensity Return Bait BallViews Sonar ViewReal Time Sonar RTS Window Understanding Sonar HistoryFreeze Frame Bottom Presentation Sonar Zoom View 200/83 kHz Split Sonar ViewKey Functions POWER/LIGHT KeyBig Digits View Circular Flasher ViewWAY Cursor Control Key Menu KeyExit Key Powering Up the Unit Menu SystemNormal Operation Exit Normal operation by powering your Fishing System offStart-Up Options Menu Normal Simulator System StatusExit System Status by powering your Fishing System off Self Test Accessory TestExit the Simulator by powering your Fishing System off SimulatorSensitivity To adjust the SensitivitySonar X-PressTMMenu Highlight Sensitivity on the Sonar X-PressTMMenuUpper Range To adjust the Upper RangeTo adjust the Lower Range Lower RangeBottom Lock Chart SpeedZoom Level Bottom RangeTo use Beam Select Sonar Menu TabBeam Select Highlight Beam Select on the Sonar main menuFish ID+TM To change the Fish ID Sensitivity settingTo change the RTS Window setting Fish ID SensitivityKHz Sensitivity Bottom ViewZoom Width Depth LinesNoise Filter Surface ClutterMax Depth To change the Water Type setting Alarms Menu TabWater Type Low Battery Alarm Depth AlarmFish ID Alarm Temp AlarmTo change the Alarm Tone setting Alarm ToneSetup Menu Tab Highlight Alarm Tone on the Alarms main menuUnits Temp User ModeUnits Depth Units DistanceRestore Defaults Triplog ResetSelect Views Depth Offset Select ReadoutsTemp Offset To change the Speed Calibration setting TroubleshootingSpeed Calibration Finding the Cause of Noise Display ProblemsProblem Possible Cause IsolationGlossary SpecificationsSonar Terms 531447-1A343cEng.qxd 11/11/2005 918 PM 531447-1A343cEng.qxd 11/11/2005 918 PM Receiver See Transmitter 531447-1A343cEng.qxd 11/11/2005 918 PM Contact Humminbird