Humminbird 343c manual Alarms Menu Tab, To change the Water Type setting

Page 23

531447-1_A_343c_Eng.qxd 11/11/2005 9:18 PM Page 44

Water Type

(Advanced)

Water Type configures your unit for operation in fresh or salt water. The Water Type menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).

NOTE: In salt water, what would be considered a large fish might be 2 to 10 times bigger than a large fish in fresh water (depending on the type of fish you are seeking). The salt water setting allows for a greater range in fish size adjustment to account for this. Also, make sure that the Water Type is set accurately, especially in salt water, as this affects the accuracy of deep water depth readings.

Alarms Menu

To change the Water Type setting:

1.Make sure you are in Advanced User Mode, then highlight Water Type on the Sonar main menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Water Type setting. (Fresh, Salt, Default = Fresh)

Alarms Menu Tab

From any view, press the MENU key twice to access the Main Menu System. The Alarms tab will be the default selection.

NOTE: When an alarm is triggered, you can silence it by pressing any key. The alarm will be silenced, and will not be triggered again until a new instance of the alarm condition is detected.

39

40

Image 23

Contents 343c Operations Manual Thank You Table of ContentsSpecifications Glossary Contact Humminbird Alarms Menu TabSetup Menu Tab TroubleshootingHow Sonar Works DualBeam Plus Sonar High Sonar Intensity Return Bait Ball What’s On the DisplaySonar View ViewsFreeze Frame Understanding Sonar HistoryReal Time Sonar RTS Window Bottom Presentation 200/83 kHz Split Sonar View Sonar Zoom ViewCircular Flasher View POWER/LIGHT KeyBig Digits View Key FunctionsExit Key Menu KeyWAY Cursor Control Key Menu System Powering Up the UnitNormal Simulator System Status Exit Normal operation by powering your Fishing System offStart-Up Options Menu Normal OperationSimulator Self Test Accessory TestExit the Simulator by powering your Fishing System off Exit System Status by powering your Fishing System offHighlight Sensitivity on the Sonar X-PressTMMenu To adjust the SensitivitySonar X-PressTMMenu SensitivityLower Range To adjust the Upper RangeTo adjust the Lower Range Upper RangeBottom Range Chart SpeedZoom Level Bottom LockHighlight Beam Select on the Sonar main menu Sonar Menu TabBeam Select To use Beam SelectFish ID Sensitivity To change the Fish ID Sensitivity settingTo change the RTS Window setting Fish ID+TMDepth Lines Bottom ViewZoom Width KHz SensitivityMax Depth Surface ClutterNoise Filter Water Type Alarms Menu TabTo change the Water Type setting Temp Alarm Depth AlarmFish ID Alarm Low Battery AlarmHighlight Alarm Tone on the Alarms main menu Alarm ToneSetup Menu Tab To change the Alarm Tone settingUnits Distance User ModeUnits Depth Units TempSelect Views Triplog ResetRestore Defaults Temp Offset Select ReadoutsDepth Offset Speed Calibration TroubleshootingTo change the Speed Calibration setting Isolation Display ProblemsProblem Possible Cause Finding the Cause of NoiseSonar Terms SpecificationsGlossary 531447-1A343cEng.qxd 11/11/2005 918 PM 531447-1A343cEng.qxd 11/11/2005 918 PM Receiver See Transmitter 531447-1A343cEng.qxd 11/11/2005 918 PM Contact Humminbird