ASSEMBLY
Sport Bar
Rear of
Vehicle 
Supports
20
22 BOTTOM VIEW
• Fit a support to one side of the sport bar.
•Insert a #8 - 32 x 15/8" (4,13 cm) screw through the support, the sport bar and out through the support.
•Fit a #8 acorn lock nut to the end of the screw.
•While holding the acorn lock nut with an adjustable wrench or pliers, tighten the screw.
•Repeat this procedure to fasten the other support to the sport bar.
•Turn the vehicle on its side.
•Insert two #10 x 3/4" (1,9 cm) screws into the holes (behind the rear wheels) in the underside of each rear wheel well, through the vehicle and into the ends of the sport bar. Tighten the screws.
•Next, insert two #10 x 3/4" (1,9 cm) screws into the holes (in front of the rear wheels) in the underside of each wheel well, through the vehicle and into the ends of the sport bar. Tighten the screws.
Sport Bar Support
PUSH
DOWN
Side
Fender
PULL
UP
21SIDE VIEW
•Fit the sport bar assembly into the holes in the top side of the vehicle.
•Push down firmly on a sport bar support while pulling up on the side fender to fit the sport bar into the vehicle.
•Repeat this procedure on the other side of the vehicle.
Door
23 SIDE VIEW
• Fit a door into the groove on the side of the dash.
Hint: Each door is designed to fit one way. If the door does not fit, try the other door.
13 |