Scan mode operation
You can save channels into memory and then use scan mode to monitor those channels from lowest to highest. If the radio detects a signal on a channel, it stays on that channel as long as the signal is received; when the signal stops, the radio continues scanning.
When it detects a signal, the radio stays on the channel until you press the
Channel Up button or the signal stops.Resume scan
08 10 11 12
13 14 15 17
The radio scans about
5 channels in 0.5 seconds.
Using the radio in scan mode
To activate scan mode, press
You must have at least two channels in memory to start a scan.
You cannot transmit while in scan mode.
To save a channel into memory, select the channel, then press the
To remove a channel from memory, set the radio to that channel, then press the
When the radio stays on a channel, press Channel Up to leave that channel and resume scanning.
To end the scan, press the
Uniden MHS125 Radio Owner’s Manual |