UHF CB - OPERATION
SCANNING with PRIORITY CHANNEL
The scan function scans channels that are in the scan memory and stops at an active channel. Whichever channel you have selected when SCAN begins becomes the Priority Channel. SCAN will check the priority channel every 1.5 seconds.
To initiate scanning:
1. Press SCAN momentarily to begin scanning. The SCAN icon flashes on the display.
2. Press PTT, INSTANT or any function key to cancel SCAN.
If SCAN is cancelled while stopped on a busy channel that channel will be the exit channel.
If SCAN is cancelled while scanning then the unit will exit to the priority channel which is the current channel when SCAN is turned ON.
SCANNING - SCAN MEMORY
You can only scan channels which are currently in the scan memory. By default all channels are active in the scan memory.
To add or remove channels from the scan memory:
1.Select a channel using scroll 
or 
.
2.Press and hold MEM .
REPLY DELAY
While scanning, the GPS105 stops at a busy channel and receives a transmission.
When the received signal is over, the unit will wait for 3 seconds for the return of the signal, otherwise the radio resumes scanning.
10